User manual DANE-ELEC Z PEN

[. . . ] Take the time to become familiar with the lights and buttons on the receiver. Off On - Stand alone Blinking - Pause - Charging* Once your document is complete, hold the button until all the LEDs turn on, then stay off. [. . . ] The receiver will turn itself off automatically after being idle for 10 minutes · When the receiver battery LED (right) starts blinking, you have less than 10 working minutes until the receiver shuts down. Only after charging the receiver, will you be able to turn it on again. ⷠThe Pause button extends the automatic turn-off of the receiver to 30 minutes (the Power led will start blinking when entering power saving mode); when you resume writing (pen down), the receiver will exit Pause mode and the Power led will stop blinking. The RESET button (small hole in the back of the receiver) should be pressed only if the receiver is stuck . ⷠLow Quality Zone ­ Directly in front of the receiver, there is a one inch (2. If you want to set the date and time of your files, open the Viewer application and go to Tools > Set Clock To replace the ink cartridge, pull on the tip to remove the used cartridge. This indicates that the receiver is now ready to be used with the digital pen. as you write , the data is stored in real-time as files in the receiver's flash memory. To add a new page, open the clip, change the sheet of paper and replace the receiver. A new page will be started in the file automatically Note: You can place the receiver at any of the four paper edges (at the bottom if your are a left-hander for example). Wherever the receiver is positionned, there should be no physical interference (finger, hand, etc. This means that your fingers cannot rest on the transparent tip of the pen while you write; they should be on the grip. [. . . ] For more information, please check the user's guide or visit www. For more information, please check the user's guide or visit www. [. . . ]