User manual DEXAPLAN VT 623

[. . . ] VIDEO DOOR INTERCOM VIDEO DOOR ENTRY SYSTEM VT 623 Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page Proper use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page Package contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page Equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page Technical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] A suitable existing 2 cable can be used if available (wire cross section min. Avoid laying the connection cable directly next to other electrical cables as this adversely affects the image and sound quality. [32] of the wedge shaped bracket if necessary. Put the connection cable and if applicable the two-core cable for an optional door opener through the cable opening hole. In doing so, plan a sufficient cable length for the connection to the stations. Outdoor station / Indoor station: Mounting with wall bracket (see Fig. Hold the wall bracket [3 and 16] at the desired mounting point and mark the four drill holes on the wall with a pencil. Pay attention when laying the cable through the wall that the cable opening [29 and 46] is aligned with the cable. When laying the cable through the wall, guide the cable through the cable opening of the corresponding wall bracket. Fix the wall bracket in place to the wall using the four mounting screws [9 and 10] and four wall plugs [8 and 11]. Outdoor station: Mounting with wall bracket and wedge shaped bracket (see Fig. E) The wedge shaped bracket changes the horizontal alignment of the outdoor station by 30°. You can mount it on the left or right side of the door by turning it upside down. Hold the wedge shaped bracket [15] at the desired mounting point and mark the four drill holes on the wall with a pencil. When laying the cable through the wall, guide the cable through the cable openings of the wall bracket and the wedge shaped bracket [29/32]. Fix the wedge shaped bracket in place to the wall using the four mounting screws [10] and wall plugs [11]. Fix the wall bracket [16] to the wedge shaped bracket using the four fixing screws [5]. Indoor station: Hanging on the wall without wall bracket The indoor station can also be hung on the keyhole slots [49]. Drill two holes at the desired mounting position (Ø 5 mm) with horizontal spacing of 4. 6 cm. Screw the two mounting screws [9] into the drilled holes so that the screw heads protrude approx. Provisionally lay the connection cable [14] from the intended installation location of the indoor station to the intended installation location of the outdoor station. Using the connection cable, connect the outdoor station [1] to the indoor station [2] according to the connection diagram (see Fig. If desired, connect an optional door opener [62] (not included in the package contents) with a two-core cable (not included) to the outdoor station according to the connection diagram (see Fig. [. . . ] The camera image is displayed on the monitor and the operating status LED [35] lights red. The monitor image disappears when the monitor button is pressed again or automatically after approx. 60 seconds and the operating status LED lights green again. Position 1: Position 2: Position 3: 2x "Ding-Dong" short melody longer melody "For Elise" Maintenance + cleaning !For stubborn dirt, clean the surfaces with a soft, fluff-free, slightly moist cloth without cleaning additives. [. . . ]