User manual EARLEX SS77

[. . . ] It is recommended that a RCD (residual current device) rated at 30mA is fitted into the mains supply socket for added protection against electric shock. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. CAUTION ! Check the state of your plaster before starting work. Steam can loosen weak, porous or poorly bonded plaster - which also loosens readily if cracked, holed or if the steam plate is held in one position for too long after the paper is soaked. A hollow sound indicates that you should proceed only with extreme care - stopping immediately if you hear a cracking sound or plaster starts to break loose. [. . . ] Now move the plate to the spot immediately next to the one just steamed - from which the paper should now easily come away with a little help from a wallpaper scraper. Working this way should enable continuous paper removal although it may be necessary to steam for longer periods with some papers, or if not completely removed first time. Operate steamer until water level is low, then unplug unit and allow to cool for at least 2 minutes before removing filler cap - Beware of steam - and re-filling unit. Always store unit empty. SAFETY CUT-OUT A safety cut-out is fitted to prevent overheating the element if the water boils low. Wait for 2 minutes before removing filler cap then re-fill with water. The cut-out will self reset and steam be produced again within 5-15 minutes. The cut-out will not protect the element if a part filled unit is tilted during use in a way which enables part of the element to be out of the water for longer than 15-20 seconds. OTHER USES FOR THE STEAM PLATE Artex® - Normally Artex® can be removed using the same method as for wallpaper although the steaming time will be longer. CAUTION: Some textured finishes may contain asbestos which may be hazardous to health and which are subject to licensing controls operated by the HSE (Health & Safety Executive). Vinyl Floor Tiles - Vinyl floor tiles can also be removed if the plate is left long enough for the heat to penetrate the adhesive. Once the adhesive is hot it softens and the tile can be peeled from the floor. Sterilising Soil - To sterilise soil in seed trays or greenhouses rake the soil to obtain a fine surface. Leave the steam plate on each section, for 2 to 2. 5 minutes which should ensure that the steam has penetrated through the surface. Killing Weeds - Steam will kill weeds on paths and patios without the use of chemicals. You will need to steam the weeds for 1 to 1. 5 minutes in order to kill them. SMALL STEAM PLATE (Optional Accessory - Not included in all kits) DANGER FROM STEAM. Always be aware that steam is being produced whilst the tool is in operation. This tool can be used to strip wallpaper in awkward areas, ie around door frames and in corners etc. Use similarly to the large steam plate, steaming one area whilst stripping a previously steamed area. This will ensure quick efficient removal of the wallpaper. Strips hard to reach areas JET NOZZLE CLEANER (Optional Accessory - Not included in all kits) IMPORTANT Always check the suitability of materials before steam cleaning. Always test a small area of the material - preferably a portion that is normally unseen - and allow to dry before starting the full cleaning task. ASSEMBLING THE TOOL The Universal Handle (AC302) is used in conjunction with the Jet Nozzle Cleaner. Align the outline triangle on the handle with the triangle on the accessory. Push the handle into the accessory and twist so that the solid triangles on the handle and accessory are aligned (see Diagram 1). [. . . ] If the fitted plug is cut off from the mains lead then the plug must be disposed of safely. NEVER under any circumstances insert such a plug into a 13 amp socket. NEVER under any circumstances use the appliance or mains lead without the fuse cover fitted. This is the little cover fixed into the base of plug to hold the fuse in place. [. . . ]