User manual ENERMAX PRO 87 PLUS

[. . . ] Ignoring connector's wrong insertion prevention design by attaching a connector to a device in wrong orientation. Connecting too many devices to one cable unit by using additional adaptor (Y cables). [. . . ] Exceeding the extension cable's loading capacity could trigger its circuit breaker and cut off the power. If you want to add the UPS (Uninterruptible Power Supply) for your system, please choose adequate Watts/VA capacity UPS. * If you intend to add other appliance powered by the same UPS, such as monitor or printer, please use higher capacity UPS according to all connected devices' rated power draw. * Please do not mistake VA capacity as Watts, or use insufficient power UPS. This would result in less UPS battery runtime or the inability to power the system in battery mode. 1 BTX/ EEB/ CEB/EPS12V This PSU does not support MB with ISA expansion slot, which might require ­5V power. When the system is turned off, or goes into ACPI S3/S4 sleep mode, the PSU fan will keep dissipating the remaining heat for 30 ~ 60 seconds and prolonging system lifetime. #2 When assembling or maintaining the system, please remove AC cord from AC inlet, or turn ON/OFF switch into "OFF" position. The ENERMAX CordGuard lock can fix your AC cord tightly to the PSU, so that it will not be easily detached and avoid shut-downs of your PC. Set your PSU into the chassis, and please Press two sides of the CordGuard lock Together, and set it into CordGuard holder near the AC inlet. When assembling or maintaining the system, please remove AC cord from AC inlet, or turn I/O switch into "O" position. 4+4P (8P) CPU +12V, in split mode 4-pin configuration supports certain single CPU systems. [. . . ] Turn I/O switch of power supply into "I" position, and reboot your system. Contact technical support of the respective manufacturer of the component which you think might be the cause to the problem. [. . . ]