User manual GENUIS V1000

[. . . ] English WEEE Warning Message Symbol for Separate Collection in European Countries This symbol indicates that this product is to be collected separately. The following apply only to users in European countries: This product is designated for separate collection at an appropriate collection point. For more information, contact the retailer or the local authorities in charge of waste management. This device must accept any interference received, including interference that may cause undesired operation. [. . . ] Press the [T] again, the camera switches to the digital zoom ( ) automatically and zooming continues. NOTE Digital zoom works by enlarging the center portion of an image through interpolation. The digital zoom is used to achieve magnification levels up to approx. four times. -24- English Using the Flash The flash is not only for taking pictures when there is insufficient light, but also when the subject is in shade or in backlight conditions. Press the flash button to cycle your camera through the various flash modes. The flash will not activate when continuous shooting or movie recording. Auto flash: Flash fires automatically when shooting conditions require extra lighting. Red-eye reduction: Flash strobes to let the subject's eyes adjust to the flash, then fires again to take the actual image. Your camera will detect the subject brightness and use the flash only when required. Force on: Flash fires every time you take a photo, regardless of lighting conditions. Press shutter button to take a picture. NOTE The flash charging time may increase when the battery is slow. The available flash settings are limited depending on the REC mode you selected. Using the Macro Your camera is equipped with a macro function that allows you to focus on very close subjects. In macro mode you can focus on subjects 10 cm from the lens when in the maximum wide angle setting and 40 cm in the maximum telephoto setting. Press shutter button to take a picture. Using the Self-timer & Burst Use the self-timer to set a delay from the time the shutter button is pressed to the time the image is shot. Double: Record two images in a shot after pressing the shutter release button 10 to 12 seconds. Burst: Keep pressing the shutter button fully to take continuous shooting. Press the shutter button to take a picture. NOTE When using the self-timer function, be sure to use a tripod or place the digital camera on a level, stable surface. -26- English Using the Aperture Priority In this mode, you can set an aperture value to match the brightness. Press the shutter button to take a picture. NOTE The larger the aperture value the smaller the lens opening, allowing less light to enter the camera. Using the Shutter Priority In this mode, you can set a shutter speed to match the brightness. Faster shutter speeds allow you to take a sharp picture of a moving subject while slower speeds create a trail effect and allow you to shoot without a flash in dark areas. Press shutter button to take a picture. Using the Manual Exposure You can manually set the shutter speed and aperture to achieve a particular effect. Use the SET button to switch between aperture value and shutter speed control. Press the shutter button halfway , and the difference between the standard exposure and the selected exposure appears in red. -27- English Using the Stabilizer With more sensibility and faster shutter speed to bright up the pictures, effectively prevent blur image caused by hand shack or target movement. User the smile Capture 1. [. . . ] This is extremely convenient for sending the images to a photo developing service or for printing on a direct print function compatible printer. Press the MENU button, then use the four-way control to select DPOF ( ) and press the SET button. To reset all DPOF settings to initial default, select [Reset] in this step. After you finished all image settings, press the SET or MENU button to apply it. 1. [. . . ]