User manual HUBBELL LIGHTING MIC-GS

[. . . ] Make sure that it is not left on the dashboard or the rear tray of a car etc. Be sure to mount labels on cartridges correctly, as failing to do so may cause an MD to become stuck in the changer. Wipe the surface of the MD cartridge from time to time with a soft dry cloth. [. . . ] On a rainy day or in a very damp area, moisture may condense on the lenses inside the unit. In this case, remove the MD and wait for about an hour until the moisture evaporates. Be careful not to splash juice or other soft drinks onto the unit or discs. The model and serial numbers are located at the bottom of the MD changer. Refer to these numbers whenever you call upon your Sony dealer regarding this product. Cautionary notice for opening and closing the door If you press on the transparent window too hard, it may break or cause injury. (If the ignition key is in the OFF position, the light automatically goes out after one minute. Make sure the MD's shutter is closed before inserting it into the magazine. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Be sure to use only the supplied mounting hardware for a safe and secure installation. * Connect the Bus cable to its terminal with unit's V mark and Bus cable's v mark aligned. Under the passenger's seat or floor installation / Installation sous le siège du passager ou sur le plancher Decide on the installation position, and remove any dirt or stains from that surface. Place the changer onto the mounting pad 2, then peel the backing and stick 2 to the floor. Be sure to insert each connector securely, as vibration through driving may cause a poor connection. For connecting two or more changers, the source selector XA-30 (optional) is necessary. How to detach and attach the protection cover Push in and slide the protection cover off. Glove box or console box installation / Installation dans une boîte à gants ou sur un boîtier de console Tear off the backing, and attach the double-sided adhesive tapes 3 to the bottom of the unit. Remove any dirt or stains from the surface you're going to mount the unit on, then attach the unit. [. . . ] Glove box or console box installation / Installation dans une boîte à gants ou sur un boîtier de console Tear off the backing, and attach the double-sided adhesive tapes 3 to the bottom of the unit. Remove any dirt or stains from the surface you're going to mount the unit on, then attach the unit. Before attaching the unit, be sure that nothing interferes with the operation of the unit, and that the unit does not interfere with the glove box or console box cover. [. . . ]