User manual KRESS 122 AS ANNEXE 413

[. . . ] The symbols used in these instructions and, if applicable, on the power tool serve to bring your attention to potential dangers when working with this power tool. You must understand the significance of these symbols/notes and comply with them in order to make its use more efficient and safer. The safety warnings, notes and symbols are not a substitute for regulation measures for accident prevention. -WARNINGFor a potentially dangerous situation which could lead to physical injury or material damage. [. . . ] EN ing screws as well as for drilling wood, metal, ceramics and plastic. Remove the battery from the device before undertaking any work on the EN device. -WARNINGUse only original KRESS batteries with the voltage given on the type plate of your machine. use only the battery chargers and batteries listed in the illustrated instructions. Because of the danger of self-discharging, NiMH batteries should be stored at ambient temperatures of between 0°C and 25°C where possible. Battery care Never charge batteries at temperatures lower than 5°C or higher than 45°C. Never charge batteries in an environment with high air humidity or a high ambient temperature. If the batteries are not used for a prolonged period, store them partially charged in a cool place. Or even better: Insert the battery into the charger while it is plugged into the mains and ready for operation, as the charger switches to trickle charge when the charging process is completed. This is the best course of action with regard to the service life of the battery and in order to keep it fully operational. Do not leave the battery in the charger when the charger is not ready for operation. This is especially important if you notice that the device is no longer functioning at full power. To ensure maximum service life, do not recharge the battery immediately when it has only been in use for a short period. If possible, wait until it has reached its lower capacity limit before recharging it. When this happens, it requires an excessive amount of energy, which means that the battery becomes discharged sooner and is subject to higher wear. Completely charge the battery before using your power tool for the first time. Battery with lithium-ion technology Total discharge protection The "Electronic discharge protection function" protects the LI battery against total discharge. Should the battery discharge, the power tool is switched off by a protective circuit. -WARNINGDo not continue to press the On/Off switch after an automatic shutdown of the power tool. Temperature-dependent overload protection The LI battery is equipped with NTC temperature monitoring which only permits charging within a temperature range of 5 °C - 45 °C. Operation If you notice that you have to charge the battery more and more frequently, it is spent and must be replaced. Workplace lighting (optional) The lamp 7 allows you to cast more light on your working area where lighting conditions are unfavourable. [. . . ] Spare parts / exploded view Exploded views and spare parts lists are available on our home-page http://spareparts. Before disposing of batteries, cover the battery contacts with the battery cap. Return used or faulty battery packs via your specialist dealer or the KRESS Customer Service department or dispose of them in the prescribed manner in public waste disposal facilities. It has effective protection against internal overpressure and short circuiting as well as devices for the prevention of violent rupture and dangerous reverse current flow. [. . . ]