User manual KRESS 500 SBLR-1

[. . . ] Before the first operation check that the mains voltage corresponds to that given on the machine nameplate. The holding button 5 on the side of the switch can be pressed for continuous operation. To release the continuous operation merely depress the switch, which makes the holding button spring back automatically. [. . . ] Ensure that the drill is not allowed to jam for longer than 2 - 3 seconds. Continuous operation under strong load and low speed can overheat the motor. Our equipment is designed in accordance with European regulations (EN standards) for the utmost safety of the user. The machines are interference-suppressed in accordance with EN 55 014. The fully automatic spindle locking makes possible quick and easy changing of the tool in the drill chuck. For soft drill shafts, it may be necessary to retighten after a short time!However, should you operate the machine on a continuous basis over long periods of time we recommend that you send us the machine for thorough cleaning and an inspection. This will spare you unnecess-ary repair expenses and increase the machine's service life. Typically the A-weighted noise levels of the machine are: sound pressure level 77 dB (A); sound power level 88 dB (A). Do not dispose of electric tools together with household waste material!Recycle raw materials instead of disposing as waste The machine, accessories and packaging should be sorted for environmental-friendly recycling. These instructions are printed on recycled paper manufactured without chlorine. Subject to change without notice Avant de mettre la machine en marche, il convient de lire entièrement la notice d'utilisation et d'observer les consignes de sécurité données dans cette notice ainsi que les consignes de sécurité générales relatives aux outils électriques précisées dans la brochure ci-jointe. This electro-tool was manufactured with high precision and subjected to rigorous factory quality controls. Therefore, we guarantee the cost-free correction of fabrication or material defects that occur within 24 months of the date of purchase by the end user. We reserve the right to repair defective parts or replace them with new parts. [. . . ] Therefore, we guarantee the cost-free correction of fabrication or material defects that occur within 24 months of the date of purchase by the end user. We reserve the right to repair defective parts or replace them with new parts. Improper use or handling as well as opening of the machine by unauthorised repair agencies voids the guarantee. [. . . ]