User manual KRESS 6800 E

[. . . ] Double insulation Our equipment is designed in accordance with European regulations (EN standards) for the utmost safety of the user. Machines with double insulation always carry the international symbol. It is essential that you observe the following safety provisions and directions: 1. [. . . ] Switch with locking knob for continuous operation The machine is set into operation by depressing the switch (1) in the handle grip. for continuous operation depress the locking knob (2) located in the side of the switch. To release continuous operation merely depress the switch again and the lock will automatically disengage. Electronic speed control The belt speed can be preselected in the range from 140­230 m/min with the adjusting disc (8). The optimum belt speed should be established at the start of sanding with test runs. We cannot make a recommendation, since several factors, such as workpiece surface, workpiece condition, state of the sanding belt, graining, the sanding finish can be influential. Working with the Belt Sander Always follow the grain of the wood to produce a perfect finish on wooden surfaces. No pressing force is necessary; the machine's own weight is perfectly sufficient. For reasons of safety and to achieve optimal results the following should be observed: The machine must be clear of the workpiece before it is started and stopped!Sanding belt recommendations We recommend the following sanding belt grain for different materials: Material Solid wood Coarse sanding Fine sanding Veneer Chipboard Plastics Steel Paint removal Sanding belt grain 40­ 60 80­150 150­220 60­150 80­150 80­150 40­ 60 In case of doubt concerning the best suited sanding belt grain for a given job, always start with the finer grain. Sanding belt changing Prior to sanding belt changing, the belt adjusting knob (3) should be turned counter-clockwise while the machine is running to shift the belt by approximately 2 to 3 mm beyond the rollers in the direction of the open machine side. The sanding belt that is to be newly mounted could scrape against the machine casing. For sanding belt changing pull the lever (6) out of the casing and turn it clockwise by 180°. ensure that the direction of the arrow on the inside of the belt matches the arrows on the machine. Turn the lever (6) counter-clockwise back by 180° and allow it to engage. During a trial run the sanding belt is adjusted with the belt adjusting knob (3) in such a manner that its outer edge concludes with the sanding belt support. [. . . ] Information about noise/vibration Measured values correspond with EN 50144. Consignes de sécurité et protection contre les accidents Parcourir entièrement la notice d'utilisation avant de mettre la machine en service, suivre les consignes de sécurité de cette notice, de même que les consignes de sécurité générales relatives aux outils électriques dispensées dans la brochure fournie avec la notice. Of breakdown send machine post-free to our company or to Service-Agent of your country and attach completed guarantee slip. [. . . ]