User manual KRESS 900 HEX-2

[. . . ] Turn the locking grip 3 clockwise until the curved handle sits tightly. To bring the locking grip back into position over the curved grip again, it can be lifted, turned to the required position and latched. For mounting at the side on the right or left of the curved handle, proceed in a similar manner but make sure in doing so that the lugs 1 of the spacer notch in the recesses 11 provided in the extension of the ventilating slot on the rubber head. [. . . ] To do this, pull the clamp off in the direction of the arrow and push it on again after emptying. The machine is fitted with a quick-change (connecting link) system, enabling sanding tools to be changed easily without the aid of an additional tool. Before mounting any new sanding sheets 16, dust and dirt must be removed from the backing pad 12. Press the sanding sheets or polishing tools onto the backing pad and make sure that the bore holes of the sanding sheet match the bore holes on the backing pad. Only use original Kress sanding and polishing tools with the pressure-sensitive connecting link. Only perfect sanding sheets will give a good sanding performance and protect the machine. Less contact pressure gives a better sanding performance and protects the machine and sanding tools. Different rubber backing pads and sanding wheels should be used depending on the material. The abrasive power and the sanding finish are determined primarily by the choice of sanding disc (grain), speed of the rubber backing pad and contact pressure (ssee application table). Place the whole sanding area of the eccentric disc sander onto the material which requires sanding. When changing the backing pad carrier plate 15, pull off the sanding sheet or polishing tool, respectively. Hold the backing pad carrier plate 15 firmly and tighten the screw 17 firmly with a Torx screwdriver. The most suitable combinations are best determined by carrying out a practical test. Removing paintwork Soft wood Hard wood Veneer 180 120 40 400 240 80 2/3 4/5 5 Switchset Rubberbacking Soft hard soft Soft soft/ hard super-soft soft Acrylic glass) the eccentric disc grinder can be fitted with the appropriate polishing tools, for example, a lamb's wool attachment or a polishing felt/sponge (auxiliary). Select low speed for polishing (step 1 ­ 2) in order to avoid excess heating of surface. Work in the polish, applying moderate pressure, in a crosswise or circular motion and then allow to dry slightly. [. . . ] Therefore, we guarantee the cost-free correction of fabrication or material defects that occur within 24 months of the date of purchase by the end user. We reserve the right to repair defective parts or replace them with new parts. Improper use or handling as well as opening of the machine by unauthorised repair agencies voids the guarantee. [. . . ]