User manual KRESS AB 180

[. . . ] User action Action for working with the device, start with light pressure and increase the pressure slowly until the desired operation is achieved. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The term "power tool" in warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. [. . . ] Otherwise there is danger of kickback when the cutting tool jams in the workpiece. Pay attention that the base plate rests securely on the material while sawing. When the cut is completed, switch off the machine and then pull the saw blade out of the cut only after it has come to a standstill. In this manner you can avoid kickback and can place down the machine securely. Do not brake the saw blade to a stop by applying side pressure after switching off. Use suitable detectors to determine if utility lines are hidden in the work area or call the local utility company for assistance. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. While reading the operating instructions, unfold the graphics page for the machine and leave it open. Jig saw V~ Nominal voltage Watt Input power Watt Output power min-1 min-1 500. Idling speed stroke number n0 The machine is intended for making separating cuts and cut-outs in wood, plastic, metal, ceramic plates and rubber while resting firmly on the workpiece. It is suitable for straight and curved cuts with mitre angles to 45°. Pressing the swung-out front edge of the circuit closer/breaker 1 will move it back to the Off position. Restarting protection (AB 180) The restarting protection feature prevents uncontrolled restarting of the machine after an interruption in the power supply. to restart the operation , switch the On/Off switch 1 to the Off position and start the machine again. Full-wave control electronics (420 ST E) The electronics are switched off by turning the adjusting wheel to the max. Presetting the Stroke Rate In devices with a setting dial 2, you can select the speed using the setting dial 2 depending on the area of application. When under load, the digital electronic control provides for more power. It should be noted that the values given are standard values which may vary according to thickness and hardness of material, grain direction, and also to the condition of the saw blade. The optimal orbital action setting for the respective application can be determined through practical testing. The following recommendations apply: Select a lower orbital action setting (or switch it off) for a finer and cleaner cutting edge. For soft materials and when sawing in the direction of the grain, work with maximum orbital action. adjustments are made by loosening the clamping wheel 6 beneath the handle. [. . . ] The threaded pin of the knobtype handle permits readjustment if a greater downward pressure is required according to material, or if the tip of the threaded pin has been re-ground. Do not use accessories made by other manufacturers, as these are not tested by KRESS. Wipe off the accessible plastic parts regularly with a cloth without cleaning agent. The movable supporting roller for the saw blade should be given a drop of oil from time to time. [. . . ]