User manual KRESS AMT 132

[. . . ] Before operating the machine, please read through the operating instructions completely, follow the Safety Instructions in this manual as well as the general Safety Instructions for Power Tools in the accompanying booklet. Important instructions, which should be read before starting operation, and which we strongly recommend observing: ­ For charging the batteries, only use a charger which is recommended by the manufacturer and never use the recommended charger to charge other electrical equipment. ­ Any machines and batteries that are not being used should be kept separately in a dry place that is high up or locked, out of the reach of children. For safety's sake, a battery charger connected to the mains should also be permanently supervised. [. . . ] Rapid charging is only possible when the temperature of the battery is between +5 °C and +45 °C. Remove the battery from the charger and reconnect or allow to cool off to room temperature, then recommence charging. the charging process begins automatically as soon as the battery is in the permissible temperature range. Blinking red light: The battery is defective or there is a short between the charging contacts. Should charging still not be possible, please send the battery and battery charger to our nearest service centre. Notes for the correct use of the battery: ­ To obtain the maximum service life, do not recharge the battery immediately after a short period of use but, if possible, discharge to the lower capacity limit and then recharge. The resulting excessive current flow leads to quick discharging and increased wear of the battery. ­ An increasingly shorter operating time per recharging of the battery is an indication that the battery is worn out and must be replaced. The clamping system has the advantage of being able to change the tools without requiring any other aid. When changing the tool, make sure that the sawblade receptacle is free from any material residue such as wood or metal chips. Turn the clamping lever 10 clockwise through 90° to the stop and hold firmly. To lock, press the tip of the tool onto a wooden block until the clamping lever 10 springs back to its original position. Turn the clamping lever 10 clockwise through 90° as far as the stop and hold firmly in this position. This prevents the machine from being switched on unintentionally as well as any unwanted battery discharge. Using the On/Off switch 6 the number of infinitely variable strokes can be controlled and adapted to the specific treatment for the differing materials. Low range for treating glass, ceramics and metal, and also for sawing using the tenon saw blade. Wipe off the accessible plastic parts regularly with a cloth without cleaning agent. From time to time, a drop of oil should be applied to the moveable roller guide for the tool. The pendulum stroke settings "0" and "1" are selected using the pendulum stroke switch 3. If you make heavy use of the equipment for an extended period of time, we recommend returning it together with the charger to our servicing department for a thorough inspection at regular intervals. This prevents high repair costs and extends the service life of your equipment. Kress takes back worn-out machines for the purpose of resource-saving recycling. [. . . ] This electro-tool was manufactured with high precision and subjected to rigorous factory quality controls. Therefore, we guarantee the cost-free correction of fabrication or material defects that occur within 24 months of the date of purchase by the end user. We reserve the right to repair defective parts or replace them with new parts. Improper use or handling as well as opening of the machine by unauthorised repair agencies voids the guarantee. [. . . ]