User manual KRESS HLG 2000 E

[. . . ] - The hot-air blower is constructed in such a way that it produces a concentrated stream of air without additional nozzles. - Never point the hot-air stream at persons and never look directly into the jet orifice on the blow-out tube. - Switching on and off must be carried out by means of the switch on the hot-air blower and never by inserting or extracting the plug from the mains socket! [. . . ] The hot-air blower HLG 2000 E makes possible an electronic continuously adjustable temperature setting 80­ 600 °C with a large volume of air of up to 400 litres/min. Double insulation Our equipment is designed in accordance with European regulations (EN standards) for the utmost safety of the user. Machines with double insulation always carry the international symbol. Safety instructions and prevention of accidents Before operating the machine, please read through the operating instructions completely, follow the Safety Instructions in this manual as well as the general Safety Instructions for Power Tools in the accompanying booklet. Important information which you must take note of: The HLG 2000 E produces hot air to a max. This high temperature is attained by having the air flow past a glowing resistance wire. Temperature setting the filament becomes red hot, without producing a naked flame however. The user should, however, take the necessary care when working with inflammable materials at these high temperatures. - Do not use the hot-air blower in rooms in which easily inflammable materials, liquids or gases are present. Danger of fire and explosion when working with plastics, paint, lacquer and similar materials. Toxic gases may develop, therefore work only in well ventilated rooms!- Do not hold blow-out tube close to objects during or immediately after use!Put the hot-air blower away in such a way that the still warm blow-out tube does no harm. Some sample applications Paints and enamels can be cleanly removed with the aid of a spatula (potentiometer position 3­6 as required). Frozen water pipes can be thawed without damage (temperature may be adjusted as required). Removing wallpaper with the aid of hot air, especially useful in the case of ingrain wallpapers. Soldering with tin solder, as well as tin coating of car body- and sheet-metal parts (potentiometer position 6 = max. Dry paints and knifing fillers with hot air (potentiometer position 1­4, depending on permissible temperature). [. . . ] The guarantee may only be enforced when defects are reported without undue delay (including shipping damage). If the tool is defective, please complete the guarantee card and return the unit, guarantee card and a brief description of the problem to the responsible service location. The guarantee obligations assumed by us shall exclude any further claims on the part of the buyer, in particular the right to recission of a sale, reduction and the assertion of damage claims. [. . . ]