User manual KRESS KSV 200

[. . . ] Set the saw plate to the minimum cutting depth and tighten with the wing nuts. Block the saw spindle of the type 6066 circular saw by pressing the arresting button (19), and unscrew and remove the tension screw (23) using the Allen wrench (13). Remove splitting wedge (12), splitting wedge adapter (17) and plain washer after loosening the Allen screw (16). [. . . ] Insure suffcient lubrication: before every second cut push the oil pump button to pump extra oil into the guide groove in addition to force-feed lubrication. ­ Only after this thirty minute period should you use the machine for more difficult cuts and greater cutting depths. Never use waste oil ­ the impurities in the oil would become deposited in the lubrication channels and lead to blockages. We recomend the use of standard chain lubrication oils whose consistency has been especially developed for use in chain saws. ­ Do not continue sawing if the oil level in the tank falls below the minimum mark (26). ­ Clean the oil fill spout thoroughly every time before adding more oil. This prevents saw dust from getting into the tank and causing blockage of the oil feed. ­ To fill the tank, press in the knob (2) of the oil pump and turn to the right until the arrows on the tank and the knob match up. Turn knob (2) to the left until the arrows on the tank and the knob match up and the knob pops up. In this position, oil flows constantly into the chain guide, even when not in use. The advantage of constant lubrication: The initial friction of the chain saw is less and the life of the saw is prolonged. Please close the tank when the machine is not in use (to protect the environment)!­ If you press the knob of the oil pump and release it again while the oil feed is open, oil is pumped into the guide groove of the bar in addition to the force feed lubrication. The oil tank of the chain saw should reach the MINIMUM level after about thirty minutes of uninterrupted cutting. [. . . ] When installing a new chain on the chain guide, please note the rotational direction of the saw chain. The cutting edges must face in the direction of rotation, as indicated by the symbol on the transparent safety shield. Se till att tillräckligt med olja tillförs: manövrera oljepumpens knapp före vartannat snitt, därigenom pumpas ytterligare olja till styrspåret förutom tvångssmörjningen. [. . . ]