User manual KRESS WS 2100

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The term "power tool" in warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. Safety rules use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. [. . . ] EN Cutting discs or other cutting tools running with overspeed can fly apart and cause injuries. Blunt or damaged router bits cause increased friction, can become jammed and lead to imbalance. Otherwise there is danger of kickback when the cutting tool jams in the workpiece. Take protective measures if there is danger of formation of combustible or explosive dust during operation that can be hazardous to health. Wear a dust mask and work with a dust/chip extraction unit, if possible to connect. Always wait until the machine has come to a complete stop before placing it down. The tool insert can jam and lead to loss of control over the power tool. During operation, always ensure that the mains and extension cable is to the rear away from the device. Move the switch to the "OFF" position before removing the plug from the plug socket. When the tool is reconnected to the mains accidental starting of the machine is avoided, thus reducing the risk of accidents. Tools not in use must be locked away safely in a dry place out of the reach of children. Fixed power supply Fixed power supply Damaged mains cables must not be used. English 19 To clamp the tool, you lock the spindle 3 by pressing the locking button 4. You can remove the tool by continually turning the open-ended spanner. After you use the insertion tool, perform a test run with an overspeed and make sure that no-one is within reach of the rotating insertion tool. If there is contact between the tool and the support surface, there is a danger of losing control of the machine. Switching On and Off To switch on the machine, push the On/Off switch 5 forward and press it down at the front to lock on. To switch off the machine, press down the On/Off switch 5 at the rear so that the switch springs back to the off position. Preselect speed (Option) In devices with a setting dial 6, you can select the speed using the setting dial 6 depending on the area of application. Working with the milling motor Wear protective glasses and hearing protection. When you use a drill stand or a mill/drill unit (possibly with a milling table), you must refer to the notes in the instructions for use provided there. Also note that you must add the alignment fences as far as possible on the milling cutter, the hand deflector (screen) must be set down as tightly as possible on the workpiece surface and, for milling work, you must always use equipment that can guarantee safe use of the tool, for example, alignment fence, auxiliary bearings, automatic feeders or a non-return block for milling work. [. . . ] , damage caused by penetration of water or other fluids, cut and damaged cables, motor damage and mechanical damage caused by inappropriate overloading, wear parts e. Carbon brushes, drill chucks, chuck keys, worn drilling spindles, motors, mains cables, batteries, saw blades, grinding discs, dust bags, accessories in general (drill bits, chisels etc. Details of the various toll wear parts can be obtained from http:// spareparts. The warranty may only be enforced when defects are reported without undue delay (including shipping damage). [. . . ]