User manual LA CROSS TECHNOLOGY WT-3143A QUICK START GUIDE

[. . . ] Since the beginning of time, man has been fascinated with the measurement of time and has devised more accurate machines to trap and measure time. Today, time is precisely measured in the United States by the most accurate clock in North America, the Atomic Clock of the US National Institute of Standards and Technology, Time and Frequency Division in Boulder, Colorado. A team of atomic physicists continually measures every second of every day to an accuracy of ten billionths of a second per day. These physicists have created an international standard, measuring a second as 9, 192, 631, 770 vibrations of a Cesium 133 atom in a vacuum. [. . . ] For time zones outside of PT, MT, CT or ET you must manually set the time using the Manual Time set button on the back of the movement. When the battery is installed the second hand will advance eight seconds (two seconds per step x four steps). For the initial setting it is recommended to stand the clock in an upright position near a window. Within five minutes the clock will either receive the WWVB signal and set itself to the exact time, or it will determine that the signal is not receivable at its current location and time of day. If a signal is not receivable it will fast-forward the hands to the 4, 8, or 12 o'clock position and search for WWVB each hour until a signal is received. If the time is manually set the clock will continue to periodically search for a signal and automatically reset the hands when the signal is received. Select a location to place your radio controlled clock where it will be at least six feet away from a TV, computer, air conditioner or other household electrical appliances. The WWVB time signal will easily penetrate Masonry and wood framed buildings. WWVB will penetrate almost every residential building and most steel buildings if they have adequate windows. It is not possible, however, for WWVB to penetrate most indoor shopping malls and rooms in the center of large office buildings that do not have windows. In buildings that WWVB cannot penetrate you may set the time using the manual time set button. When the clock is exposed to the WWVB signal it will automatically set the hands to the exact time. La Crosse Technology clocks do not receive or process radio controlled time signals from Germany's DCF 77, Japan's J Ga AS, or England's MSFs atomically regulated transmitters. For more information on the NIST and radio controlled time, see www. boulder. nist. gov/timefreq/ Troubleshooting The wonderful advantage of owning a La Crosse Technology radio controlled clock is that it is virtually trouble free. If it does not receive a signal consider the following: Battery - The La Crosse Technology clock must have a fresh battery to receive and process the time signal. It should be at least six feet from computers, TVs, air conditioners, other RadioControlled clocks and other electrical appliances that cause interference. Weather - Electrical storms between you and Colorado during the night will interfere with the WWVB signal. Although we cannot control the weather we can help you predict it (see www. lacrossetechnology. com). Daylight Savings Time The National Institute of Standards and Technology and WWVB encode a special DST "bit" in the WWVB transmission for DST. Your La Crosse Technology clock will read this information and automatically advance the hands one hour in the spring and eleven hours in the fall. [. . . ] In addition, this warranty does not cover any defects resulting from improper use, unauthorized repairs, or faulty batteries. In the event of a warranted problem please return the clock postage prepaid to the address below. La Crosse Technology will repair or replace your clock with the same or similar model free of charge. LA CROSSE TECHNOLOGY WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS CLOCK. [. . . ]