User manual LEXICON 960L V2.4 INSTALLATION AND RELEASE NOTES REV 3

[. . . ] Pay particular attention to precautions that appear throughout this document. Please note the following before proceeding to the steps below: · The installation process requires the 960L serial number, which is located on the back of the mainframe. The serial number consists of four digits, followed by a dash, followed by four more digits. [. . . ] Enter the serial number as it appears on the back panel of the 960L mainframe. The following message will appear: Please re-enter serial number for verification . x_ 4 960L Version 2. 4 Software Installation Instructions & Release Notes 6. Enter the serial number again as it appears on the back panel of the 960L mainframe. After the system has started, verify that the software has been installed properly. To do this, press the CONTROL button, then the SYSTEM button, and read the version information on the screen. Once this process is complete, configure the system and continue working. It is recommended to read the 960L Owner's Manual to make the most of the 960L. REVERTING TO A PREVIOUS SOFTWARE VERSION To revert to a previous version of 960L software, follow the same procedure outlined on pages 3 to 5 using the release CD for the desired software version. There is one special consideration: When upgrading to Version 2. 4, the software recognizes prior versions of user registers and automatically converts them to a compatible format. Therefore, when performing a "back-rev, " erase all user registers before inserting the release CD. It is recommended to save them first, noting the software version of the user registers. Using the front panel standby button, power down the system, wait a few seconds, then power back up. As soon as the LARC2 receives power, go to Menu Mode by pressing and holding the PROGRAM and MACHINE keys at the same time. Hold them until the following message appears: Requesting menu mode from 960L . Select this item from the menu: 7) Erase User Registers & Restore Factory Default Settings Once this process is complete, follow the installation instructions outlined on pages 3 to 5 using the release CD for the desired software version. When checking the software version (see Step 7 above), please refer to the release notes of the software version being installed to determine software revisions for the LARC2 and the 960L mainframe. 5 Installation Instructions & Release Notes RELEASE NOTES Lexicon The list below includes features of the 960L Software Version 2. 4 that are not fully covered in the owner's manual: · When configuring systems with two DSP cards, there are no longer two soft buttons labeled CONFIG 1 and CONFIG 2. When pressed, a menu will appear allowing selection of the DSP card for configuration. The ability to use double-button presses to access options has been removed in order to support future functionality. [. . . ] Once set, the input/output routings are saved with the configuration and will be automatically recalled when that DSP configuration is loaded. Input/output routings saved with each configuration may become invalid if the order of the input/output cards is changed or if an input/output card is removed from the unit. If this occurs, simply reset the input/output routings. · · · · · 6 960L Version 2. 4 Software · Installation Instructions & Release Notes Manual fader adjustment may be prevented when the fader is automatically positioned near the top or bottom of its physical range, even if the parameter is not set to its maximum or minimum value. [. . . ]