User manual LEXICON CORE 32 V4.21 RELEASE NOTES REV 0

[. . . ] Core 32 Version 4. 21 Release Notes PC Platform · Version 4. 21 supports ASIO2, not including ASIO2 direct monitoring. It also supports sample accurate sync and call back protocol, which provide improved performance on the PCI bus by maximizing the number of input/output streams available at once. [. . . ] When using an MMIO application, all channels will be available for selection in the Punch and Reverb source/destination lists when the Monitor button is enabled. Only the channels that are in use will be available for Punch and Reverb routing when the MMIO application is in play. All channels will be available for Punch and Reverb routing when the application is in Stop or when no application is running. When using the MMIO drivers, the PC-90 user interface must be maximized to hear reverb through the PC-90. Only dry audio will be heard when the user interface is closed. · · · · Lexicon, Inc. 070-14579 | Rev 0 | 11/01 Tel 781-280-0300 Fax 781-280-0490 www. lexicon. com Customer Support Tel 781-280-0300 Fax 781-280-0495 (Sales) Fax 781-280-0499 (Service) Version 4. 21 Release Notes · Note the following when using the Punch/Monitor feature: - Lexicon When using an MMIO application, Punch/Monitor can only be changed if no audio is playing or if the application is closed. If the message "Another application is currently using the installed devices to play audio" appears, stop playing audio or exit the application. When using CoolEdit or Cakewalk, Punch/Monitor is available in Stop Mode and Record Mode. Stop Mode can be used to monitor the audio source while the Lexpanel is open. Record Mode can be used to monitor the audio source on channels that have been record enabled in the application. When using Acid, Emagic/Logic Audio MMIO, SoundForge, or Wavelab, Punch/Monitor can be used when the Lexpanel is open or closed. When the Lexpanel is open, it is possible to listen to the audio source when the application is in Stop Mode. When the Lexpanel is closed, the VU meters in the application must be enabled to monitor the audio source. - - · Changes made to the ASIO Control Panel that is launched from Cubase are reflected in the ASIO Lexpanel that is launched from the taskbar. However, changes made to the ASIO Lexpanel will not be reflected in the ASIO Control Panel (for example, PC-90 input/output settings). TROUBLESHOOTING · Lost clock is difficult to regain. [. . . ] · The Lexpanel Routing tab does not display all connected devices. Select the Refresh Devices button in the Routing tab, then open the Lexpanel. [. . . ]