User manual MARANTZ AS4250

[. . . ] Be careful not to lose removed screws, etc. Parts Included (Left) * Feet (2) (Right) * Bar (1) Core (2) (for 50" monitors) Stand assembly screws M4 (4) Screwdriver Display mounting screws M6 (4) Hexagonal wrench * Handling instructions (these instructions) Core mounting screws - M6 hexagon socket head cap screws (4) Specifications Model: AS4250 External dimensions: (W) 814 x (H) 192x (D) 400 mm (W) 32. 0 x (H) 7. 6x (D) 15. 7 inches Weight: 3. 2 kg 7. 3 lbs 40AW851010 Always Heed the Following Before Use. . . Symbols Various symbols are used in this Instruction Manual for the safe and proper use of the product as well as preventing any injury or damage to persons or property. Please have a good understanding of these matters before reading the main text of the manual. Ignoring this indication and improper handling could be the cause of personal injury such as a serious injury or death. [. . . ] - Do not install the Plasma Display near air conditioner air outlets or in places where vibrations are strong. - Do not install the Plasma Display in humid or dusty places or places exposed to soot or vapor (such as in kitchens, near humidifiers, etc. ). - When installing the Plasma Display, leave sufficient space around it, as shown in the diagram. Failure to do so could cause heat to build up inside, leading to fire. 50mm 50mm 50mm 50mm - Hold the Plasma Display securely when mounting the units on it. Failure to do so could cause the Plasma Display to fall, resulting in injury. - When installing the Plasma Display on a stand with casters, be sure to block the casters. If the stand should move, the Plasma Display could fall, resulting in injury. - The Plasma Display is heavy, so be sure to install in a stable place and take measures to prevent it from tipping over and causing injury. It should be unpacked and moved by a minimum of two people, holding it at the top and bottom. Failure to do so could cause the Plasma Display to fall, resulting in injury. NOTES Avoid dusty or humid rooms and rooms filled with soot or cigarette smoke. The Plasma Display's screen could get dirty, resulting in poor picture quality. Avoid places where the screen is exposed to direct sunlight or strong artificial light. If surrounding light should shine on the screen, the screen will appear white and be hard to see. Additional fall prevention measures - Either use the tip prevention fitting included with the display to fix the plasma display to a wall, pillar or other strong place or use the holes on the back on the stand to fix to a table, etc. . (Do no use with the separately sold ceiling mount unit or wall mount unit. ) - Pay attention to the rope when moving the Plasma Display. - The screws for fastening the display to the wall, a pillar or a stand are not included. Please obtain screws suited for the surface on which the display is to be mounted. Installing the Plasma Display on the Stand For both 42-inch and 50-inch plasma displays Preparations 1. Open the top of the cardboard in which the plasma display is packed and remove the three pieces of styrofoam. Lay the plasma display down. Place the protective sheet in which the plasma display was wrapped under the screen and lay the plasma display on top. [. . . ] Insert the plasma display on the stand and fasten it. Use four of the included M6 display mounting screws to fasten the monitor to the stand. Install with the arrow facing the front. 2. Fasten the bar to the feet using the four included stand assembly screws (M4). T ON FR FR ON T Bar installation position for 50" 2. Mount the cores on the feet. * Fasten using the 4 included core mounting screws (M6 hexagon socket head cap screws). [. . . ]