User manual MARANTZ CD5001

[. . . ] Model CD5001 User Guide CD Player CLASS 1 LASER PRODUCT LUOKAN 1 LASERLAITE KLASS 1 LASERAPPARAT TEXT CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION: POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU'AU FOND. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] (digital coaxial output) connector The music signals during play are output digitally from this coaxial output connector. * Digital signals are not output during pitch control play. C DIGITAL OUT OPT. (digital optical output) connector The music signals during play are output digitally from this optical output connector. * Digital signals are not output during pitch control play. F MAINS CONNECTION Plug the mains cord into a mains outlet providing the right voltage. D REMOTE CONTROL IN and OUT connectors Using the supplied remote control connecting cable, these connectors enable this player to be connected to a Marantz component equipped with remote control connectors. These connections make it possible to control an entire system that centers on the amplifier or other such component. 11 ENGLISH Rear panel 6. BASIC OPERATIONS Playing CDs · Stopping play DISC TTL RNDM TRK PROG A­ B RPT 1 PITCH EDIT PEAK TTL TIME TEXT 12 34 56 78 9 10 11 12 13 14 15 16 17 18 19 20 ENGLISH 2 DISPLAY POWER 3, 4 5 1 4 7 PROGRAM 2 5 8 0 3 6 9 CANCEL RANDOM QUICK REPLAY 5 Press the 7 button on the player or remote control unit during play. · Pausing play PITCH RESET AMS A-B SCROLL/ RECALL REPEAT RANDOM QUICK REPLAY TEXT TIME REMOTE CONTROLLER RC5400CD 1. Turn on the power of the amplifier to which the player is connected, and use the input selector on the amplifier to select "CD" (the player's input source which has been connected). Place the CD to be played in the extended disc tray while ensuring that the label with the printed text is facing up. 2. 3. During play, press the 8 button on the player or remote control unit to temporarily suspend play. To resume play from the place where it was temporarily suspended, press the 3 button or 8 button on the player or the 3 button or 8 button on the remote control unit. Caution: When the tray is opened by pressing the disc tray OPEN/ CLOSE 0 button, the try will close automatically in 30 seconds. When placing a disc, be careful not to have your finger caught by the disc tray or have the disc damaged. · Removing the CD In the case of a single (8 cm) CD, align it with the indentation in the center of the tray. 4. Press the OPEN/CLOSE 0 button on the player to retract the disc tray. Pushing the front of the disc tray lightly also causes the tray to be retracted. Once the disc tray has been retracted, "TOC Reading" appears on the display, after which the total number of CD tracks and total playing time are displayed. In the case of a disc that supports CD-TEXT, the album title is displayed, and then the total number of CD tracks and total playing time are displayed. Press the 3 button on the player or remote control unit to start play. Adjust the volume level at the amplifier. 5. After play has finished, press the OPEN/CLOSE 0 button on the player to extend the disc tray, and remove the CD. After the CD has been removed, press the OPEN/CLOSE 0 button again to retract the disc tray. The disc tray should always be retracted when the player is not in use. 12 BASIC OPERATIONS · Specifying the number of a track to be played (direct search) Select the number of the track to be played directly by pressing the numeric buttons (0 to 9) on the remote control unit. To select track number 10 or above, use the numeric buttons to select the higher digit first and then select the lower digit. Once the number of the track is selected, play will start automatically. Example: To play track 3 Press the "3" numeric button. DISPLAY POWER · Playing a previous or subsequent track (track skip) Advancing to a subsequent track 1 2 3 Press the ¡/¢ button on the player or ¢ button on the remote control unit for the number of times equivalent to the number of tracks through which play is to be advanced. Example: To play track 12 Press the "1" numeric button. DISPLAY POWER Returning to the start of the track now playing or a previous track 1 2 3 Within 1. 5 second, press the "2" numeric button. DISPLAY POWER When the 4/1 button on the player or 4 button on the remote control unit is pressed, play returns to the start of the track now playing. Play returns to the previous track which is equivalent to the number of times the button was pressed. 1 2 3 13 ENGLISH Playing a specific track BASIC OPERATIONS Playing a specific part of a specific track · Searching a specific part of a track (search) While listening to a track being played, it is possible to search a specific part of that track by a forward or backward search. ENGLISH · Playing the last 10 seconds again during play (quick replay) PROGRAM CANCEL Forward searching through the track now playing 0 RANDOM QUICK REPLAY When the QUICK REPLAY button on the remote control unit is pressed during play, play will be returned by 10 seconds, and the same section will be played again. The search (forward search) mode is established by holding down the ¡/¢ button on the player or ¡ button on the remote control unit. [. . . ] 0. 0025% (1 kHz) Wow & flutter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Cross-interleave Reed Solomon code (CIRC) Audio output . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 mW/32 ohms (variable maximum) Digital output Coaxial output (pin jack) . . . . . . . . . . . . . . . . . . . . -19 dBm Optical readout system Laser . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]