User manual MARANTZ PD4230V

[. . . ] Model PD4230V User Guide Plasma Monitor IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment Read these instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. A grounding type plug has two blades and third grounding prong. The wide blade or third prong are provided for your safety. [. . . ] Press the POWER STANDBY button (on the remote control) or the Power button (on the unit) to turn off the unit. The monitor's POWER/STANDBY indicator turns red and the standby mode is set (only when turning off the unit with the remote control). OFF TIMER To set the off timer: The off timer can be set to turn the power off after 30, 60, 90 or 120 minutes. The timer starts when the menu turns off. 30 60 90 120 0 OFF TIMER 30 VOLUME To adjust the sound volume: 1. Press and hold the VOLUME button (on the remote control or the unit) to increase to the desired level. Press and hold the VOLUME button (on the remote control or the unit) to decrease to the desired level. When five minutes remain the remaining time appears until it reaches zero. OFF TIMER 28 MUTE To mute the audio: Press the MUTE button on the remote control to mute the audio; press again to restore. DISPLAY To check the settings: 1. If the button is not pressed for approximately three seconds, the menu turns off. DIGITAL ZOOM Digital zoom specifies the picture position and enlarges the picture. ( ) To change the size of the picture: Press the ZOOM+ button and enlarge the picture. A press of the ZOOM- button will reduce the picture and return it to its original size. To change the picture position: Select the position with the LM buttons. Press the EXIT button to delete the pointer. To cancel the off timer: 1. The off timer is canceled. OFF TIMER 0 Note: After the power is turned off with the off timer . . . When you are leaving the room or do not plan to use the system for a long period of time, turn off the power of the monitor. 15 WIDE Operations Wide Screen Operation (manual) With this function, you can select one of six screen sizes. The screen size switches as follows: NORMAL ANAMORPHIC STADIUM ZOOM 2. 35:1 14:9 Original image Information is lost on both sides. The squeezed film image is expanded to fulfill the entire screen at a ratio of 2. 35:1. Black bands do not appear at the top and bottom but information is lost on the left and right margins. · This feature is available when the input signal is video, component (480I, 480P, 576I, 576P, 720P, 1080I) or RGB (525P or 625P signal from a scan converter). * If black bands appear on the top and bottom in the full size screen, select the 2. 35:1 size screen to avoid phosphor burnin. 14:9 size screen When a 720P or 1080I signal is input: ANAMORPHIC 2. 35:1 NORMAL size screen (4:3) The normal size screen is displayed. * The picture has the same size as video pictures with a 4 : 3 aspect ratio. * This feature is available when the input signal is video, component (480I, 480P, 576I, 576P) or RGB (525P or 625P signal from a scan converter). The image is expanded in the horizontal direction. * Images compressed in the horizontal direction ("squeezed images") are expanded in the horizontal direction and displayed on the entire screen with correct linearity. [. . . ] (Except for *3) Computer input signals supported by this system Model Signal Type Dots 640 640 lines 400 480 848 480 852 480*1 800 600 IBM PC/AT compatible computers*8 1024 768 1152 864 1280 768 1280 1280 1280 1360 1360 1376 1280 768*9 800*9 854*9 765 768 768 1024 1680 1050*9 1600 1200 1920 1200*9 1920 1200RB*9 640 480 Apple Macintosh*6, 832 624 *8 1024 768 1152 870 1440 900*9 Work Station 1280 1024 (EWS4800)*8 Work Station (HP)*8 1280 1024 Work Station 1152 900 (SUN)*8 Work Station (SGI) IDC-3000G PAL625P NTSC525P 1280 1024 1024 768 1280 1024 768 640 576 480 Sync Polarity Presence Screen mode Horizontal Vertical frequency frequency Horizontal Vertical Horizontal Vertical NORMAL FULL (kHz) (Hz) (4:3) (16:9) 31. 5 70. 1 YES YES*2*3 YES YES NEG NEG 31. 5 59. 9 YES*3 YES YES NEG NEG YES 37. 9 72. 8 YES*3 YES YES NEG NEG YES 37. 5 75. 0 YES*3 YES YES NEG NEG YES 43. 3 85. 0 YES*3 YES YES NEG NEG YES 51. 1 100. 4 YES*3 YES YES NEG NEG YES 61. 3 120. 4 YES*3 YES YES NEG NEG YES 31. 0 60. 0 ­­ YES YES POS POS YES*3 31. 7 60. 0 ­­ YES YES NEG NEG YES*3 35. 2 56. 3 YES YES YES POS POS YES 37. 9 60. 3 YES YES YES POS POS YES 48. 1 72. 2 YES YES YES POS POS YES 46. 9 75. 0 YES YES YES POS POS YES 53. 7 85. 1 YES YES YES POS POS YES 63. 0 99. 8 YES YES YES POS POS YES 75. 7 120. 0 YES YES YES POS POS YES 48. 4 60. 0 YES YES YES NEG NEG YES 56. 5 70. 1 YES YES YES NEG NEG YES 60. 0 75. 0 YES YES YES POS POS YES 68. 7 85. 0 YES YES YES POS POS YES 80. 5 100. 6 YES YES YES NEG NEG YES 67. 5 75. 0 YES YES YES POS POS YES 45. 1 56. 2 ­­ YES YES POS POS YES 48. 0 59. 8 ­­ YES YES POS NEG YES 56. 0 69. 8 ­­ YES YES NEG POS YES 49. 7 60. 0 ­­ YES YES NEG NEG YES 53. 1 60. 0 ­­ YES YES NEG NEG YES 47. 7 60. 0 ­­ YES YES POS POS YES 47. 7 60. 0 ­­ YES YES POS POS YES 48. 3 59. 9 ­­ YES YES NEG POS YES 64. 0 60. 0 YES*4 YES YES POS POS YES 80. 0 75. 0 YES*4 YES YES POS POS YES 91. 1 85. 0 YES*4 YES YES POS POS YES 108. 5 100. 1 YES*4 YES YES POS POS YES 65. 3 60. 0 ­­ YES YES NEG NEG YES 75. 0 60. 0 YES YES YES POS POS YES 81. 3 65. 0 YES YES YES POS POS YES 87. 5 70. 0 YES YES YES POS POS YES 93. 8 75. 0 YES YES YES POS POS YES 106. 3 85. 0 YES YES YES POS POS YES 74. 6 60. 0 ­­ YES YES NEG NEG YES 74. 0 60. 0 ­­ YES YES NEG NEG YES 35. 0 66. 7 YES*3 ­­ ­­ Sync on G Sync on G YES 49. 7 74. 6 YES ­­ ­­ Sync on G Sync on G YES 60. 2 74. 9 YES ­­ ­­ Sync on G Sync on G YES 68. 7 75. 1 YES ­­ ­­ Sync on G Sync on G YES 56. 0 60. 0 ­­ YES YES NEG NEG YES 64. 6 60. 0 YES*4 YES YES NEG NEG YES 75. 1 71. 2 YES*4 YES YES NEG NEG YES 78. 1 72. 0 YES*4 ­­ ­­ ­­ ­­ YES 61. 8 66. 0 YES ­­ ­­ C Sync C Sync YES 71. 7 76. 0 YES ­­ ­­ C Sync C Sync YES 81. 1 76. 1 YES*4 ­­ ­­ C Sync C Sync YES 49. 7 60. 0 YES ­­ ­­ ­­ ­­ YES 63. 9 60. 0 YES*4 ­­ ­­ ­­ ­­ YES 50. 0 59. 9 31. 4 31. 5 NEG NEG NEG NEG YES YES YES YES YES*7 YES*7 YES*7 YES*7 RGB select*5 HDMI Memory ­­ STILL ­­ STILL ­­ ­­ ­­ WIDE2 WIDE1 STILL STILL ­­ ­­ ­­ ­­ ­­ STILL ­­ STILL ­­ ­­ STILL WIDE1 WIDE3 WIDE1 WIDE1 WIDE2 WIDE1 WIDE1 WIDE2 STILL ­­ ­­ ­­ WIDE4 ­­ ­­ ­­ ­­ ­­ WIDE2 WIDE3 ­­ ­­ WIDE1 WIDE1 ­­ ­­ ­­ ­­ ­­ ­­ ­­ ­­ ­­ ­­ MOTION NO YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES YES NO YES YES YES YES NO YES YES YES YES YES NO YES YES NO NO NO NO ­­ YES NO NO NO NO YES YES YES YES YES YES YES YES YES NO NO 4 5 7 8 9 41 42 19 17 11 12 13 14 15 43 44 24 25 26 27 45 51 52 80 66 21 37 22 22 53 29 30 40 47 38 54 55 56 57 58 81 88 6 16 28 39 89 29 48 59 60 61 30 62 29 31 32 37 *1 Only when using a graphic accelerator board that is capable of displaying 852 480. *2 PD4230V : Display only 400 lines with the screen center of the vertical orientation located at the center. PD4250D : Display only 640 lines with the screen center of the vertical orientation located at the center. *5 Normally the RGB select mode suite for the input signals is set automatically. [. . . ]