User manual MARANTZ PD6150D

[. . . ] Model PD6150D User Guide Plasma Monitor IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment Read these instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. A grounding type plug has two blades and third grounding prong. The wide blade or third prong are provided for your safety. [. . . ] The timer starts when the menu turns off. 30 60 90 120 0 OFF TIMER 30 VOLUME To adjust the sound volume: 1. Press and hold the VOLUME button (on the remote control or the unit) to increase to the desired level. Press and hold the VOLUME button (on the remote control or the unit) to decrease to the desired level. When five minutes remain the remaining time appears until it reaches zero. OFF TIMER 28 MUTE To mute the audio: Press the MUTE button on the remote control to mute the audio; press again to restore. DISPLAY To check the settings: 1. If the button is not pressed for approximately three seconds, the menu turns off. DIGITAL ZOOM Digital zoom specifies the picture position and enlarges the picture. ( ) To change the size of the picture: Press the ZOOM+ button and enlarge the picture. A press of the ZOOM- button will reduce the picture and return it to its original size. To change the picture position: Select the position with the LM buttons. Press the EXIT button to delete the pointer. To cancel the off timer: 1. The off timer is canceled. OFF TIMER 0 Note: After the power is turned off with the off timer . . . When you are leaving the room or do not plan to use the system for a long period of time, turn off the power of the monitor. 15 WIDE Operations Wide Screen Operation (manual) With this function, you can select one of six screen sizes. The screen size switches as follows: NORMAL ANAMORPHIC STADIUM ZOOM 2. 35:1 14:9 Original image Information is lost on both sides. The squeezed film image is expanded to fulfill the entire screen at a ratio of 2. 35:1. Black bands do not appear at the top and bottom but information is lost on the left and right margins. · This feature is available when the input signal is video, component (480I, 480P, 576I, 576P, 720P, 1080I) or RGB (525P or 625P signal from a scan converter). * If black bands appear on the top and bottom in the full size screen, select the 2. 35:1 size screen to avoid phosphor burnin. 14:9 size screen When a 720P or 1080I signal is input: ANAMORPHIC 2. 35:1 NORMAL size screen (4:3) The normal size screen is displayed. * The picture has the same size as video pictures with a 4 : 3 aspect ratio. * This feature is available when the input signal is video, component (480I, 480P, 576I, 576P) or RGB (525P or 625P signal from a scan converter). The image is expanded in the horizontal direction. * Images compressed in the horizontal direction ("squeezed images") are expanded in the horizontal direction and displayed on the entire screen with correct linearity. (Normal images are expanded in the horizontal direction. ) STADIUM size screen Note: Do not allow the displayed in 4:3 mode for an extended period. This can cause a phosphor burn-in. The picture is expanded in the horizontal and vertical directions at different ratios. [. . . ] PD4250D : Display only 640 lines with the screen center of the vertical orientation located at the center. PD5050D/PD6150D : This signal is converted to a 1024 dots 640 lines signal. *5 Normally the RGB select mode suite for the input signals is set automatically. If the picture is not displayed properly, set the RGB mode prepared for the input signals listed in the table above. [. . . ]