User manual MARANTZ SR 4500

[. . . ] 5J/PPC CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. IMPORTANT SAFETY INSTRUCTIONS READ BEFORE OPERATING EQUIPMENT This product was designed and manufactured to meet strict quality and safety standards. There are, however, some installation and operation precautions which you should be particularly aware of. [. . . ] The setting “IR=ENABLE” is shown on the FL DISPLAY. Press the or cursor button to change this to “IR=DISABLE”. Once this setting is made, the infrared sensor on the main unit is disabled. Note: Be sure to set to “IR=ENABLE” when external infrared sensors or similar devices are not connected. Otherwise, the main unit will be unable to receive remote control commands. 5J/PPC CONNECTING THE ANTENNA TERMINALS AM LOOP ANTENNA AM EXTERNAL ANTENNA FM ANTENNA FM EXTERNAL ANTENNA Connecting the supplied FM antenna The supplied FM antenna is for indoor use only. During use, extend the antenna and move it in various directions until the clearest signal is received. Fix it with push pins or similar implements in the position that will cause the least amount of distortion. If you experience poor reception quality, an outdoor antenna may improve the quality. Connecting the supplied AM loop antenna The supplied AM loop antenna is for indoor use only. Set it in the direction and position it to where you receive the clearest sound. Put it as far away as possible from the unit, televisions, speaker cables, and power cords. If you experience poor reception quality, an outdoor antenna may improve the quality. AUDIO PRE OUT UNSWITCHED 1A 120W MAX L SL C SBL R L R L R L Press and hold down the lever of the AM antenna terminal. SPEAKER B SURROUND CENTER SWITCHED 1A 120W MAX SPEAKER SYSTEMS MINIMUM 6 OHMS AC OUTLETS 120V 60HZ CONNECTING AN FM OUTDOOR ANTENNA Notes: • Keep the antenna away from noise sources (neon signs, busy roads, etc. An outdoor antenna will be more effective if it is stretched horizontally above a window or outside. Insert the hook at the bottom of the loop part into the slot at the base part. 5J/PPC ENGLISH CONNECTING THE SUPPLIED ANTENNAS SETUP After all components are connected, initial setup must be performed. 4 (Digital Fixed mode) ANALOG D4-AUTO ANALOG D1-AUTO ANALOG D3-AUTO ANALOG D2-AUTO SETUP MENU SYSTEM The SR4500 incorporates an menu on the front display, which makes various operations possible by using the cursor ( , , , ) and ENTER buttons. SPEAKERS DISTANCE setup L R C SL SR SW SBL SBR (Front L) (Front R) (Center) (Surround L) (Surround R) (Subwoofer) (Surround back L) (Surround back R) →0. Press the MENU button or the ENTER button of the remote control to enter the SETUP MENU. Press the ENTER button or the MENU button to enter the desired menu item. [. . . ] The SURROUND SPEAKER B system can not be operated with the supplied remote controller. Notes for SURROUND SPEAKER B • SURROUND SPEAKER B On/ Off is available in main room only. €¢ SURROUND SPEAKER B output terminals can be used when the SURROUND BACK SPEAKER is set NONE in SPEAKER SETUP menu. SPEAKER B button when the SURROUND BACK SPEAKER is set except NONE in SPEAKER SETUP menu. [. . . ]