User manual MARANTZ SR4320

[. . . ] R Model SR4320 User Guide Receiver CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION: POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU'AU FOND. NOTE TO CATV SYSTEM INSTALLER: This reminder is provided to call the CATV (Cable-TV) system installer's attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] · Remove the short pin when using the PRE OUT, MAIN IN terminals. Connecting PRE OUT/MAIN IN jacks Connecting with external power amplifier This receiver has enough power for normal listening but PRE OUT jacks are prepared to connect external power amplifiers for higher power output. In such a case, connect these jacks to the MAIN IN jacks or AUX IN jacks of the power amplifier. Connecting with graphic equalizer Use PRE OUT and MAIN IN jacks to connect a graphic equalizer or other analog audio processor. Note: When not used, leave these jacks connected with the supplied connecting pins. 8 VCR Monitor AUDIO OUT LR AUDIO VIDEO IN OUT IN LR VIDEO IN CVBS L R L R LR LR ANTENNA AC OUTLETS 120V 60Hz REMOTE CONTROL OUT MONITOR OUT IN UNSWITCHED 120W 1A MAX AM DSS IN GND DVD IN VIDEO VCR IN SWITCHED 120W 1A MAX OUT FM (75 ) GND SPEAKER SYSTEMS SYSTEM A : MINIMUM 8 OHMS SYSTEM B : MINIMUM 8 OHMS SYSTEM B R L PHONO IN CD IN CDR / MD IN OUT IN TAPE OUT DSS IN DVD IN IN VCR OUT PRE OUT MAIN IN L R R L AUDIO SYSTEM A LR RL LR LR DVD player AUDIO VIDEO OUT OUT LR AUDIO VIDEO OUT OUT LR Satellite tuner Notes: · Insert all plugs and connectors securely. Red connectors are used for the R (right) channel, and white connectors are used for L (left) channel. · Be sure to connect input and output of video signal properly. 9 ENGLISH CONNECTING VIDEO COMPONENTS CONNECTING REMOTE CONTROL JACKS You can control other Marantz products through this unit with the remote control unit by connecting REMOTE CONTROL terminals on each unit. The signal transmitted from the remote control unit is received by the remote sensor on this unit then the signal is sent to the connected device through this terminal. Therefore you need to aim the remote signal only to this unit. ENGLISH ANTENNA AC OUTLETS 120V 60Hz REMOTE CONTROL OUT MONITOR OUT IN UNSWITCHED 120W 1A MAX AM DSS IN GND DVD IN VIDEO VCR IN SWITCHED 120W 1A MAX OUT FM (75 ) GND SPEAKER SYSTEMS SYSTEM A : MINIMUM 8 OHMS SYSTEM B : MINIMUM 8 OHMS SYSTEM B R L MO A PHONO IN CD IN CDR / MD IN OUT IN TAPE OUT DSS IN DVD IN IN VCR OUT PRE OUT MAIN IN L SERIA MODE R R L SERI N AUDIO SYSTEM A REMOTE CONTROL IN OUT CD recorder REMOTE CONTROL IN OUT MD deck REMOTE CONTROL IN OUT CD player EXTERNAL INTERNAL EXTERNAL INTERNAL EXTERNAL INTERNAL Set the REMOTE CONTROL switch on the units other than this unit to EXT. (EXTERNAL) for this feature. 10 FM antenna FM external antenna AM loop antenna AM external antenna ANTENNA AC OUTLETS 120V 60Hz REMOTE CONTROL OUT MONITOR OUT IN AM DSS IN GND DVD IN VIDEO VCR IN UNSWITCHED 120W 1A MAX OUT SWITCHED 120W 1A MAX FM (75 ) GND SPEAKER SYSTEMS SYSTEM A : MINIMUM 8 OHMS SYSTEM B : MINIMUM 8 OHMS SYSTEM B R L PHONO IN CD IN CDR / MD IN OUT IN TAPE OUT DSS IN DVD IN IN VCR OUT PRE OUT MAIN IN L SERIAL NO. R R L AUDIO SYSTEM A Assembling the AM loop antenna 1 Release the vinyl tie and take out the connection line. Connecting the supplied antennas Connecting the supplied FM antenna The supplied FM antenna is for indoor use only. During use, extend the antenna and move it in various directions until the clearest signal is received. Fix it with push pins or similar implements in the position that will cause the least amount of distortion. If you experience poor reception quality, an external antenna may improve the quality. Connecting an FM external antenna 2 Bend the base part in the reverse direction. Notes: · Keep the antenna away from noise sources (neon signs, busy roads, etc. ). · To avoid the risk of lightning and electrical shock, grounding is necessary. Connecting an AM external antenna 3 Insert the hook at the bottom of the loop part into the slot at the base part. An external antenna will be more effective if it is stretched horizontally above a window or outside. · To avoid the risk of lightning and electrical shock, grounding is necessary. 4 Place the antenna on stable surface. 11 ENGLISH CONNECTING THE ANTENNA TERMINALS OPERATION NORMAL PLAYBACK RECEIVER SR4320 MULTI - JOG VOLUME ENGLISH BALANCE/TONE CONTROL If necessary, adjust the balance and tone control as below. SPEAKERS A B DISPLAY OFF RECEIVER SR4320 DOWN UP MULTI - JOG CLEAR MEMORY TUNING/PRESET F/P MODE JOG MODE SPEAKERS S-DIRECT SLEEP MUTE STANDBY SPEAKERS PHONES DVD VCR DSS CDR/MD TAPE CD PHONO TUNER POWER ON/STANDBY A B DISPLAY OFF CLEAR MEMORY TUNING/PRESET JOG MODE SPEAKERS S-DIRECT 1 MAIN POWER 2 SOURCE POWER 4 STANDBY POWER ON/STANDBY PHONES DVD VCR DSS CDR/MD TAP 1 MUTE 1 4 7 CLEAR 2 5 8 0 3 SLEEP 6 DIMMER 2 1 1 9 MEMO S-DIRECT F. DIRECT T. MODE P. SCAN SPKR A/B DISP. /RDS PTY DIRECTION INPUT BASS TREBLE REC TUNE/SEARCH PAUSE 2 Press the JOG MODE button on the front panel to select your desired control. Each time the JOG MODE button is pressed, the mode changes as BAL (BALANCE) TRE (TREBLE) BASS BAL (BALANCE). Turn the MULTI-JOG knob to adjust the control. CH SKIP CH SKIP DVD VCR DSS AMP 2 CDR MD TAPE CD PHONO TUNER VOLUME 4 BALANCE: Turn the knob clockwise to decrease volume of the left channel and turn the knob counter-clockwise to decrease volume of the right channel. TREBLE: Turning the knob clockwise enhance the high frequency band, while turning counterclockwise attenuates the high frequency band. BASS: Turning the knob clockwise enhance the low frequency band, while turning counterclockwise attenuates the low frequency band. You can control the tone (BASS/TREBLE) by remote control unit directly. SYSTEM REMOTE CONTROLLER RC4320SR 1 2 Press the POWER button to turn on the power. Press the function select button to select an input source. TURNING THE SOUND OFF TEMPORARILY (MUTING) Press the MUTE button to turn off the audio output temporarily. [. . . ] Marantz Spain The listening Room Audio Nord Sound Company AG Hamzeh & Partners Covecolor Pai-Yuing Co. ITM Company ADDRESS 8, Lotissement Ben Hatadi, Alger, Algerie 47 A/75 St. Waverley, VIC 3149, Australia Taborstraße 95 / Ladestraße 1, Gebäude Hangartner, A-1200 Wien, Austria P. O. Box 237, 141, Government Avenue, Manama, Bahrein 1078, Ramjoy Mohanja Lane Asadgonj, Chittagong 4000, Bangladesh Brusselbaan 278, 9320 Erembodegem, Belgium Makedonia Blvd. [. . . ]