User manual MARANTZ ST4000

[. . . ] If you need to change its voltage setting, consult your dealer your local Marantz service provider. INSTALLATION Remember the following important points when installing the Tuner. · Do not expose the component to rain or moisture, as this may cause damage to the Tuner. Never put the Tuner in the full glare of the sun or near a heat source. This apparatus is fitted with an approved moulded 13 Amp plug. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. [. . . ] Five seconds after presetting the sleep time, the system will return to the previous status and thereafter begin sleep timing. NOTES: · If you want to know the time remaining until the sleep time, press the SLEEP button once. 5 DANSK · To allow the sleep function to work properly, you need to connect the remote control terminal of the tuner to the corresponding remote control terminal of the amplifier. SVENSKA If you press the TUNING UP/DOWN button after pressing the SLEEP button, you can adjust the time by one minute at a time. PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS DEUTSCH 3. NAME FRANçaIS ENGLISH ENGLISH HOW TO PRESET DAILY The ON and/or OFF time can be preset for daily use. Before presetting DAILY make sure the power is off. RDS Display 1. RDS can be displayed only in the FM band. DAILY Presetting FRANçaIS 1. ("DAILY ON --:--" will be displayed for you to set the ON time. ) 2. Set the "hour (. . . )" you want by pressing the TUNING button, and then press the NEXT button. After you set the "minute (--)" you want in the same way as for "hour", the display will show "DAILY OFF --:--" which indicates the OFF time. Set the OFF time in the same way as you set the "ON" time. 3. Press the PRESET UP/DOWN button or the TUNING UP/DOWN button to tune to the required broadcast station. · In case the received station is broadcasting RDS, RDS will light up in the Display. Each time you press the button (within 0. 5 second), the modes will change as follows regardless of the current mode: fi PS fi CT fi PTY DEUTSCH 3. Then, the display will return to the previous status before presetting was performed. NOTE: NEDERLANDS If you turn off the power intentionally before the "OFF" time, the DAILY presets will be cancelled. (1) PS mode: "PS" will blink for about 4 seconds in the display. · If you do not receive PS Data even after switching the mode to call it up, "NO PS" will be displayed until the data is received. · When the data is received, the corresponding PS will be displayed. (2) CT mode: "CT" will blink for about 4 seconds in the display. · If you do not receive CT Data even after switching the mode to call it up, "NO CT" will be displayed until the data is received. · When the data is received, the corresponding CT will be displayed. · Be sure to press the button for more than 1 second regardless of whether RDS mode is on or off. When you press the TUNING button after your desired program is searched, you can continue to search for another program type by increasing of decreasing the frequency from the current one. NOTES: · When the same program type is not found in PTY Search mode, searching will stop and search mode will be released automatically. [. . . ] 50 dB (at 94 dB/m) Output (Level/Impedance) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 170 mV/2. 2 k ohm General Power Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 230 V AC, 50 Hz Power Consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6W Dimensions (W · H · D) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]