User manual MARANTZ VP8100

[. . . ] R Model VP8100 User Guide Video Projector CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning symbol in the triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation mark in the triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU'AU FOND. For the customers in the USA: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. [. . . ] · Do not place your hand or objects near the ventilation holes; the air coming out is hot. !0 INPUT SELECT key Select an input signal. Each time the key is pressed, the unit toggles between COMPONENT, S-VIDEO, VIDEO, and RGB inputs. 3 INTRODUCTION Connector panel and Rear ENGLISH m, v z x . TRIG. 1 TRIG. 2 RGB IN Y PB/CB PR/CR COMPONENT VIDEO IN EXT. OUT IN VIDEO IN REMOTE CONTROL S-VIDEO IN b n c /0 /3 /2 /0 /4 /1 /2 /0 z COMPONENT VIDEO IN Y, PB/CB, PR/CR connectors. Connect to the COMPONENT VIDEO output of video equipment or an A/V processor/receiver with a component video loop. , TRIG. 2 OUT Either A 12-volt signal or a 0-volt signal is sent to the equipment connected to the TRIG. 2 OUT, according to the setting in the OSD menu. Note: This cannot be used for these connectors, TRIG. 1 OUT and TRIG. 2 OUT, as the power source. x S-VIDEO IN Connect to the S-VIDEO output of a video equipment. c VIDEO IN Connect to the composite video output of a video equipment. . Adjuster button When using adjuster, press the button and loosen an adjuster. v RGB IN Connect to the analog RGB output of a computer equipment. /0 Adjuster /1 Rear adjuster Adjust the vertical angle of the projector. b REMOTE SW. (EXTERNAL/INTERNAL) When using the MARANTZ REMOTE CONTROL system, select EXTERNAL. Otherwise select INTERNAL. /2 Ventilation holes /3 IR sensor /4 AC IN Connect the supplied AC power cord. n REMOTE CONTROL IN/OUT Connect to the REMOTE CONTROL connectors of other Marantz equipment. It is then possible to control the whole system with a single Remote Controller. m TRIG. 1 OUT When the projector is turned on, a 12-volt signal is sent to the equipment connected to the TRIG. 1 OUT. This allows automatic triggering of an accessory, such as a powered up/down screen, whenever the projector is turned on or off. When the unit is turned off, no voltage is output and when the unit is turned on, 12 V is output. Note: You cannot use the connector as the power source. 4 INTRODUCTION Bottom ENGLISH w q e t r e r q Lamp cover w Lamp cover securing screw e Adjuster r Ventilation hole t Rear adjuster Adjusters How to use adjuster, adjuster button, and rear adjuster. z Adjuster button x Adjuster c Rear Adjuster PRESS DOWN UP DOWN 5 INTRODUCTION Remote Controller /0 THEATER key /1 NORMAL key x STANDBY POWER ON z c Select the NORMAL picture mode. The key toggles between NORMAL1, NORMAL2, NORMAL3 and NORMAL STD. /2 DYNAMIC key Select the DYNAMIC picture mode. The key toggles between DYNAMIC1, DYNAMIC2, DYNAMIC3 and DYNAMIC STD. v COMPONENT S-VIDEO ENTER , MENU /3 OSD key When the key is pressed, projector setting information is displayed. Then press again to clear the FOCUS pattern. b n /0 /3 /6 /9 /7 ¤0 VIDEO RGB m . /2 /5 /8 ¤1 /1 /4 THEATER NORMAL DYNAMIC /4 FULL key Select FULL mode, from four aspect ratio mode. OSD FULL SQUEEZE /5 SQUEEZE key Press to turn the SQUEEZE mode on and off. This mode is intended to use with "Anamorphic" picture material. If you are using an Anamorphically squeezed DVD or Laser Disc, this mode will "unsqueeze" the image to give proper picture geometry and enhanced resolution. 2­3 P/D 4:3 ZOOM B-LIGHT P-SHIFT V-MUTE /6 2-3 P/D key Press to turn the two to three pull down mode - automatic film detection mode - on and off. RC8000VP /7 4:3 key Select a mode from four aspect ratio modes. /8 ZOOM key Select ZOOM mode from four aspect ratio modes. B A D C E z POWER ON key Press to turn the projector on. x STANDBY key Press to turn the projector off. /9 B-LIGHT key Press to turn on or off the back-lighting of keys on the unit. c // / keys v COMPONENT key Select the COMPONENT VIDEO IN signal. ¤0 P-SHIFT key Press to turn the picture shift mode on or off. When adjusting the image position horizontally, use and keys. b S-VIDEO key Select the S-VIDEO IN signal. ¤1 V-MUTE key Mute the picture so that screen gets dark and no image is displayed. n VIDEO key Select the VIDEO IN signal. m RGB key Select the RGB IN signal. Note: FULL key, SQUEEZE key, 4:3 key, ZOOM key, 2-3 P/D key, and P-SHIFT key are available for only COMPONENT VIDEO IN, SVIDEO IN, VIDEO-IN, and RGB IN(VGA only). , ENTER key . The key toggles between THEATER1, THEATER2, THEATER3 and THEATER STD. INTRODUCTION Preparing the Remote Controller ENGLISH 1. Open the cover. CAUTION ­ Do not mix old and new batteries, and never mix different types of batteries (standard, alkaline and so on). ­ If the user does not intend to use the Remote Controller for a long time, remove the batteries. ­ The Remote Controller operation may not function if the projector's IR sensors are exposed to direct sun light or strong artificial light, or if there is an obstacle between the IR sensors and the Remote Controller. 2. [. . . ] ITM Company Marantz Domestic Sales ADDRESS 8, Lotissement Ben Hatadi, Alger, Algerie 47 A/75 St. Lalaiants, 375000 Yerevan, Armenia 4 Station Street, Thornleigh NSW 2120, Australia Taborstraße 95 / Ladestraße 1, Gebäude Hangartner, A-1200 Wien, Austria P. O. Box 237, 141, Government Avenue, Manama, Bahrein 1078, Ramjoy Mohanja Lane Asadgonj, Chittagong 4000, Bangladesh Brusselbaan 278, 9320 Erembodegem, Belgium Makedonia Blvd. Box 5604, Nicosia, Cyprus Sokolska 41, 67902 Rajecko, OKR, Blansko, Czech Republic Dali Allé 1, 9610 Noerager, Denmark P. O. [. . . ]