User manual MARTIN MAC 700 WASH

[. . . ] MAC 700 Wash user manual Dimensions All measurements are expressed in millimeters 285 120° 120° 675 365 12. 5° 66° 12. 5 xx° xx° 66 656 515 390 143 Min. c/c 530 450 270° 270° 565 © 2006 Martin Professional A/S, Denmark. No part of this manual may be reproduced, in any form or by any means, without permission in writing from Martin Professional A/S, Denmark. This product presents risks of lethal or severe injury due to fire and heat, electric shock, ultraviolet radiation, lamp explosion, and falls. [. . . ] The off setting is not saved and the system will be re-enabled the next time the fixture starts. If the system cannot correct the pan/tilt position within 10 seconds, feedback is automatically disabled. ADJUSTMENT The adjustment menu () provides manual control for making mechanical adjustments. See page 29. 14 MAC 700 Wash CALIBRATION The calibration menu () provides utilities to define offsets in software that are relative to the mechanical reset or home positions. This allows you to fine tune optical alignment and achieve uniform performance between fixtures. The other effects are calibrated relative to an arbitrary reference fixture. All offsets can be set to (the middle of their adjustment range) with the default offset command: select then press [Enter]. To calibrate effects 1. Apply power but do not strike the lamp until zoom has been calibrated. Adjust the offset until the face of the zoom lens plate is flush with the back edge of the focus plate. Pan calibration is most useful when multiple fixtures are stacked vertically. To calibrate, set zoom and tilt position for easy one-over-the-other comparison and set each fixture to the same pan DMX value. Adjust the offset as necessary to align the beam with the reference beam. Tilt calibration is most useful when multiple fixtures are arranged horizontally. To calibrate, set zoom and pan position for easy side-by-side comparison and set each fixture to the same tilt DMX value. Adjust the offset as necessary to align the beam with the reference beam. Set the offset to zero and then increase it until a clearly defined M shape with minimal light spill is projected onto the paper. To calibrate color mixing flags (cyan, magenta, yellow and CTC), project white beams with no dimming and position them for easy comparison. Adjust the offsets on the other fixtures to match the reference color. Repeat for (magenta), (yellow) and (CTC). FANS The cooling fans can be set to either full speed or thermostatically regulated operation via . In lower ambient temperature environments, regulated operation is recommended if reduced noise levels are desired. is maximized if fans are set to full speed. SOFTWARE UPLOAD The upload mode command () prepares the fixture for a software update. This command is not normally necessary, as upload mode is engaged automatically by the uploader. Control panel 15 Effects This section describes the effects in the MAC 700 Wash with reference to the DMX channels used to control them. The MAC 700 Wash has two DMX operating modes, 16-bit basic and 16-bit extended. [. . . ] Insert termination plug in output jack of the last fixture on the link. Bypass one fixture at a time by unplugging XLR in and out connectors and connecting them directly together until normal operation is regained. Install a phase-reversing cable between the fixtures or swap pins 2 and 3 in the fixture that behaves erratically. The lamp will then strike. XLR pin-out on fixtures does not match (pins 2 and 3 reversed). [. . . ]