User manual MCINTOSH CR16 SERVICE MANUAL

[. . . ] The instrument does not appear to operate normally or exhibits a marked change in performance; or E. Servicing - Do not attempt to service beyond that described in the operating instructions. Grounding or Polarization - Do not defeat the inherent design features of the polarized plug. Nonpolarized line cord adaptors will defeat the safety provided by the polarized AC plug. YOU AND THE MclNTOSH INSTRUMENT. [. . . ] YOUR OWN SYSTEM MAY USE ALL OR ONLY PART OF THE AVAILABLE COMBINATIONS. YOUR MclNTOSH DEALER WILL ASSIST YOU IN THE PROPER CHOICE OF ACCESSORIES AND COMPONENTS FOR YOUR PERSONAL SYSTEM REQUIREMENTS. The Mclntosh CR16 Remote Control system offers a wide variety of performance features and combinations for an audio and video home entertainment system. This will allow you to customize your remote control system so it will satisfy all your particular needs. Contact your Mclntosh dealer for any other specific system requirements you may have. FOUR INDEPENDENT CONTROL AREAS The CR16 is shipped with two Area Control modules installed, for area one and area two. Slots are provided to install two additional Model ACM-1 Area Control modules to allow control of two additional remote areas, for a total of four. These are CD (compact disc player or changer), TUNER, TAPE 1, TAPE 2, VIDEO and Auxiliary. Any of these six audio input signals can be selected for any remote location. PRE-PROGRAMMING CAPABILITY You can select the source program signal as well as the desired volume setting for each area before the area amplifier is turned on. HR10 HAND HELD REMOTE CONTROLLER The HR10 allows you to select the signal source and the volume level in a remote area. AREA POWER ON INDICATORS These indicators show which areas are turned on and operating. AREA PROGRAM INDICATORS These indicators show which area is selected for programming input sources and volume level. SENSOR The front panel IR sensor that accepts signals from the HR10 hand held remote controller. % VOLUME The Volume Level indicator shows the volume levels for each selected area. PROGRAM SOURCE After selecting the area to be programmed, these pushbuttons select the desired program input signal. AREA PROGRAMMING FOR SIGNAL SOURCE AND VOLUME These pushbuttons select the area to be programmed for input SOURCE signal and desired VOLUME level. This programming can be done either before or after the area is turned on and operating. After selecting the signal source and desired volume, press the area POWER switch to turn it ON. PROGRAMMING AN AREA FOR SIGNAL SOURCE AND VOLUME LEVEL PRIOR TO TURNING ON THE AREA, MUST BE DONE WITHIN TEN SECONDS AFTER SELECTING THE AREA. IF THE AREA POWER IS NOT TURNED ON WITHIN TEN SECONDS AFTER MAKING SELECTIONS, OR NO SELECTIONS ARE MADE, THE AREA PROGRAMMING WILL TURN OFF. AREA PROGRAMMING POWER ON-OFF These pushbuttons turn an area ON or OFF. [. . . ] POWER CONTROL Connector to add the cable from a Mclntosh PC-1 Power Controller. This turns on AC power to each remote area power amplifier, when the area is turned on. It also provides switched AC power for five audio accessories, two video accessories and 3 unswitched outlets. The unswitched outlets provide AC power as long as the PC-1 power cable is connected to a live AC wall outlet. 10 SYSTEM CONFIGURATION EXAMPLE: 1. [. . . ]