User manual NAPCO ACM1D DATASHEET

[. . . ] The Gemini Security System Control Panel is made compatible with easy replacement of its standard EPROM with a GeminiAccess software enhancement upgrade. GeminiAccess provides controlled access to a door by releasing a mag or electric strike when a valid Prox card or Prox keyfob is presented to an HID or GEM-PX proximity reader. Access control is integrated with the burglary functions of the GEM-X255. [. . . ] Each expanded Gem-Access module, ie. , with installed GEM-2D plug-in PCB, is capable of controlling access through 2 doors and uses a keypad location in the system for communication. Each 2-door access unit is fully supervised and reports specific troubles at system keypads (AC/DC Power, Battery Troubles), as well as tamper. And, the 2 prox readers controlled by each expanded GeminiAccess Module can be programmed to function independently on different doors, or together, controlling access for both sides of one door. Manufacturing great security products is all we do. It's that simple. TM PRELIMINARY SPECIFICATIONS: The GeminiAccess System supports HID standard 26 bit format and/or NAPCO Gemini Prox format. Recommended prox readers: · HID Prox Point Plus Model 6005B · NAPCO GEM-PX Prox Reader with Alarm Status LEDs The GEM-ACM1D also supports the use of any "Request to Exit" device and any UL 294 listed mag lock. GEM-PX Prox Reader with Alarm Status Indicators The unique GEM-PX Prox Reader includes LED status indicators for both the access and alarm system The LED's function as follows: · RED ­ Displays System Armed (on solid), system disarmed, (off) and system in alarm (blinking). · GREEN ­ Displays Ready to Arm (on solid), not ready (off). (Note: Alarm Status indication is a programmable option by Module and may be eliminated in undesirable instances, for example, where the reader is visible from outside the premises, etc. ) GEM-ACM1D Power Supply The GEM-ACM1D has an integral power supply which includes two primary linear regulators. The first regulator is used to power the panel, the readers and to recharge the battery. The second regulator is used to supply up to 1. 5A 12VDC for the door locks, which provides enough current to support two 750mA electromagnetic locks. The Door Lock Power has an option to enable battery standby with a shunt connector placed across jumper JP3 (factory default). The battery is prevented from damage caused during extended power failures with a battery drop out circuit that disconnects the battery when there is no AC present and battery voltage drops to approximately 9VDC. When AC is restored, the battery is automatically re-connected and begins to recharge. The GEM-ACM1D tests the battery under load every 4 hours and when the RESET button is pressed. The low battery condition will only restore after it passes the active test. The separation of the door lock power from the rest of the system reduces the likelihood that turning off the power to the door lock coils will affect performance of the system. The use of linear versus switching regulators significantly reduces electrical noise that may hinder the sensitivity of proximity card readers. Fire System Integration GeminiAccess includes an "Emergency Free Access" zone for integration with a fire system. [. . . ] Each presentation of the credential is logged and optionally printed (requiring GEM-PRINT module on the system). Ordering Information: GEM-ACM1D Access Control Module for 1 Door Module in metal enclosure, w/ power supply, transformer and software enhancement upgrade EPROM for Gemini Alarm Panel. GEM-1DKIT Economical GEM-PROX Kit Module in enclosure, w/ power supply, transformer, Panel Prom, GEM-PX Prox Reader with Status LED Indicators, 25 Gemini Prox Cards. GEM-1DKITA HID Reader Kit, as above, with HID Reader and 25 HID 1326 Prox. [. . . ]