User manual ONE FOR ALL URC-4220

[. . . ] Use the Cursor Keys to move the cursor in the program guide and menu screens. Use SELECT (OK) to choose options from your selected device's menu or guide. Use FAV to scan all channels, or after programming, to scan up to 10 favorite channels. Press SUBTITLE/CC once to display (or turn off) subtitles or closed captions, if available on your DVD player or cable/satellite service. [. . . ] To check for codes of other devices, repeat steps 1 through 5 (starting on the previous page), but substitute the appropriate device key for each device you are checking. In its default state, the POWER key on the One For All 4 Device Universal Remote Control will individually power your home entertainment devices on or off. However, you can also program a Master Power Macro onto the POWER key that will sequentially turn on or off all the devices with a single key press. Press and hold SET until the LED (red light) blinks twice, then release SET. For the first device you want in the power-on sequence, press its device key (e. Repeat step 3 up to three more times to add desired devices to the power-on sequence (e. To save the settings and exit the program, press and hold SET until the LED blinks twice, then release SET. After programming, point the remote control at the devices and press POWER for at least 2 seconds to sequentially turn on (or off) your devices. NOTE: When POWER is pressed for less than 2 seconds, a power command will only be sent to the currently-selected device. NOTE: The currently-selected device will always turn on or off first, followed by the remaining programmed sequence. After the master power sequence has been completed, the remote control will be set to control the first powered-on device. NOTE: If one or more devices does not have a POWER key, the power off/on sequence may be slightly delayed when the remote control signals the device(s). Press and hold SET until the LED (red light) blinks twice, then release SET. The One For All 4 Device Universal Remote Control can be set to control a second PVR, VCR, or DVD player. For example, to control a TV, a cable box, and two DVD players, re-assign the unused VCR/PVR key to operate the second DVD player as follows: 1. On the remote control, press and hold SET until the LED (red light) blinks twice, then release SET. The VCR/PVR key is now ready to be set up to control your second DVD player. To re-assign a second VCR or PVR (or DVR) to the unused DVD key, repeat steps 1 through 4 . However, in step 3 substitute VCR/PVR for DVD, and in step 4 substitute DVD for VCR/PVR. Now the DVD key will be ready to be set up as your second VCR or PVR (or DVR). NOTE: Only one device can be assigned to an unused device key at a time. In the CBL/SAT or TV mode, use the FAV key to start a 3-second scan of all channels. [. . . ] This Warranty is not transferable and does not extendto costs incurred for installation, removal or reinstallation of the product. This Warranty does not apply if in the Company's opinion, the product hasbeen damaged through alteration, improper installation, mishandling, misuse, neglect, accident, or the simultaneous use of different battery types (e. This Warranty is in lieu of all other express warranties or liabilities. No person or representative is authorized to assume for the Company any liabilityother than expressed herein in connection with the sale of this product. [. . . ]