User manual POULAN 2075

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual POULAN 2075. We hope that this POULAN 2075 user guide will be useful to you.


POULAN 2075 : Download the complete user guide (336 Ko)

You may also download the following manuals related to this product:

   POULAN 2075 (337 ko)

Manual abstract: user guide POULAN 2075

Detailed instructions for use are in the User's Guide.

[. . . ] Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. poulan. com Instruction Manual Manual de Instrucciones Manuel d'Instructions 1950 / 1975 / 2055 / 2050 / 2075 / 2150 2155 / 2175 / 2350 / 2375 / 2150PR LE Series ESPAÑOL For Occasional Use Only WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. ADVERTENCIA: Lea el manual de instrucciones y siga todas las advertencias e enstrucciones de seguridad. El no hacerlo puede resultar en lesiones graves. AVERTISSEMENT: Lire le manuel d'instructions et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves. Electrolux Home Products, Inc. [. . . ] Pull the starter rope sharply with your right hand until the engine starts. Then, squeeze and release the throttle trigger to allow engine to return to idle speed. STARTING A WARM ENGINE 1. Pull the starter rope sharply with your right hand until the engine starts. Squeeze and release throttle trigger to allow engine to return to idle speed. checked several times daily. This is the only instance when the saw should be placed on the ground with the engine running. Grip the rear handle with your right hand and the front handle with your left hand. Activate the chain brake by turning your left wrist against the hand guard without releasing your grip around the front handle. The chain should stop immediately. Braking function control CAUTION: The chain brake must be Inertia activating function control DIFFICULT STARTING (or starting a flooded engine) The engine may be flooded with too much fuel if it has not started after 10 pulls. Flooded engines can be cleared of excess fuel by pushing the choke/fast idle lever in completely (to the OFF CHOKE position) and then following the warm engine starting procedure listed above. Starting could require pulling the starter rope handle many times depending on how badly the unit is flooded. If engine fails to start, refer to the TROUBLESHOOTING TABLE or call 1-800-554-6723. WARNING: When performing the following procedure, the engine must be turned off. Grip the rear handle with your right hand and the front handle with your left hand. Hold the chain saw approximately 14 (35 cm) above a stump or other wooden surface. Release your grip on the front handle and use the weight of the saw to let the top of the guide bar fall forward and contact the stump. When the tip of the bar hits the stump, the brake should activate. CUTTING METHODS IMPORTANT POINTS S Check chain tension before first use and after 1 minute of operation. Do not cut metal, plastics, masonry, non-wood building materials, etc. Inspect the saw and repair or replace parts as necessary. CHAIN BRAKE WARNING: If the brake band is worn too thin it may break when the chain brake is triggered. The chain brake should be replaced by an autho- 10 S Keep the chain out of dirt and sand. Even a small amount of dirt will quickly dull a chain and thus increase the possibility of kickback. S Practice cutting a few small logs using the following techniques to get the "feel" of using your saw before you begin a major sawing operation. S Squeeze the throttle trigger and allow the engine to reach full speed before cutting. S Release the throttle trigger as soon as the cut is completed, allowing the engine to idle. [. . . ] MANUFACTURER'S WARRANTY COVERAGE: If any emissions related part on your engine (as listed under Emissions Control Warranty Parts List) is defective or a defect in the materials or workmanship of the engine causes the failure of such an emission related part, the part will be repaired or replaced by ELECTROLUX HOME PRODUCTS, INC. OWNER'S WARRANTY RESPONSIBILITIES: As the small off-road engine engine owner, you are responsible for the performance of the required maintenance listed in your instruction manual. ELECTROLUX HOME PRODUCTS, INC. , recommends that you retain all receipts covering maintenance on your small off-road engine, but ELECTROLUX HOME PRODUCTS, INC. , cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the small off-road engine engine owner, you should be aware that ELECTROLUX HOME PRODUCTS, INC. , may deny you warranty coverage if your small off-road engine engine or a part of it has failed due to abuse, neglect, improper maintenance, unapproved modifications, or the use of parts not made or approved by the original equipment manufacturer. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE POULAN 2075




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual POULAN 2075 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.