User manual RAYMARINE RAY101

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual RAYMARINE RAY101. We hope that this RAYMARINE RAY101 user guide will be useful to you.


RAYMARINE RAY101 : Download the complete user guide (1372 Ko)

Manual abstract: user guide RAYMARINE RAY101

Detailed instructions for use are in the User's Guide.

[. . . ] Ray101 Handheld VHF Marine Radio Owner's Handbook Document number: 81229-2 Date: February 2004 iii About this Handbook Introduction This handbook describes the Ray101 portable VHF marine radio. The Ray101 provides communications on all US, Canadian and International marine channels and receives ten weather channels. Conventions Used Throughout this handbook, the dedicated (labelled) keys are shown in bold capitals (for example: SCAN/SAVE). The LCD indicators and functions are shown in normal capitals (for example: TX). Operating procedures, which may consist of a single key-press or a sequence of numbered steps, are indicated by an arrow icon shown in the margin. Technical Accuracy To the best of our knowledge, the information in this handbook was correct as it went to press. However, our policy of continuous product improvement and updating may change specifications without prior notice. [. . . ] (HI/LO) TX Power Indicates whether transmit power is set for 5 watts (HI) or 1 watt (LO). Signal Strength Displays the relative strength of the TX and RX signals. When transmit output power is set for 1 watt, only two bars are displayed. When the output power is set for 5 watts, the full scale (5 bars) is displayed. When receiving, the bar graph indicates the strength of the signal being received. A stronger signal displays a larger number of segments in the bar graph. Chapter 4: Operating the Radio 15 Chapter 4: Operating the Radio 4. 1 Turning the Power ON and OFF Turn the PWR/VOL knob clockwise until it clicks. Beeps, illuminates the backlight at full brightness, and displays all segments and indicators for 2 seconds. Displays the software version number on the LCD but without the decimal point. If no last-used setting data exists, goes to CH 16 and high TX Power. To turn the unit OFF: Rotate the Volume knob completely counterclockwise until it clicks. D6700-1 4. 2 Setting the Volume Adjust the PWR/VOL knob to control the loudspeaker volume level. Turn clockwise to increase the volume; counterclockwise to decrease the volume. Note: Key press beep volume is also controlled by the VOL level. 16 Ray101 Handheld VHF Radio 4. 3 Setting the Squelch The Squelch circuit sets the threshold for cutting off the receiver when the signal is too weak for reception of anything but noise. To properly set the squelch, rotate the SQ knob counterclockwise until noise is heard. Then rotate clockwise until background noise disappears. D6705-1 4. 4 Setting the Power Output Press and release the HI/LO / USER key to toggle the TX power from LOW (1 watt) to HIGH (5 watts). You should switch to high power only when contact can not be made on low power in emergency situations. This procedure is specified by the FCC but is also part of marine communications courtesy and will save on battery life. Note: Some channels are limited by regulation to be low power only. If the HI/LO operation request is denied, an error tone beeps. Chapter 4: Operating the Radio 17 Overriding the Low Output Power Restriction (US only) The low power requirement on channels 13 and 67 in US mode can be temporarily overridden in cases where 1W is not sufficient. To override the LO power restriction on channels 13 or 67 and transmit at high power: Press and hold the PTT key. Output is set to HI power for as long as you hold down the HI/LO / USER key. D6698-1 Note: Channels 13 and 67 are for bridge to bridge operations only. See Appendix B: for approved usage. 4. 5 Setting the Channel Press and release the UP arrow to increment the channel number. Press and hold either key for rapid channel scrolling. 4. 6 Selecting a Weather Channel The US National Oceanic and Atmospheric Administration (NOAA) broadcasts continuous weather reports and severe weather alerts, as needed. The Ray101 is programmed to receive10 NOAA weather channels and sound an alarm if a weather alert is received. Press Channel UP/DOWN to change the WX channel 1 through Channel 10. 18 Ray101 Handheld VHF Radio Press and release the WX/BAND key again to return to normal operation. During Weather mode, the PTT, SCAN/SAVE and HI/LO / USER keys are disabled and an error beep sounds if pressed. Weather Alert Operation Weather Alert is toggled ON and OFF by pressing and holding WX/BAND key in the weather mode. [. . . ] Operations are different from that of international operations on that channel. Channel 16 is used for calling other stations or for distress alerting. The letter "B" following a channel number indicates simplex use of the coast station transmit side of an international duplex channel. Channel 70 is used exclusively for Digital Selective Calling (DSC) and is not available for regular voice communications. Appendix B: Channel List 43 International VHF Marine Radio Channels & Frequencies CH No. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE RAYMARINE RAY101




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual RAYMARINE RAY101 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.