User manual RCA RP8070

[. . . ] FCC Information EN This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. In accordance with FCC requirements, changes or modifications not expressly approved by Thomson multimedia Inc. This device generates and uses radio frequency (RF) energy, and if not installed and used properly, this equipment may cause interference to radio and television reception. [. . . ] The display shows SHUFFLE in red to indicate activation of shuffle mode. Note: Shuffling tracks among discs depends on the selected REPEAT mode. To play or select disc, refer to the section on Playing Discs. Programming Play Order You must be in Stop mode to program/store your desired track sequence. Press DISC SKIP or one of the Disc Direct Access buttons to choose a disc. Press PLAY/PAUSE to begin programmed play. Tracks Introduction This feature is most useful for newly purchased CDs. You can listen to the first ten seconds of each track as brief introduction. In play mode, press INTRO once, INTRO lights up at the selected mode section on the display. To deactivate, press INTRO again and the unit begins playing tack 1 of the disc. Recalling and Editing the Program You must be in Stop mode in order to recall and edit the program. Press PROGRAM to the next program number until you get to the programmed track you want to change. Press DISC SKIP to choose the disc and then press or to choose a replacement track. Press PROGRAM to change the current programmed track to the one you just selected. Repeating Play Order You can repeat one track, one disc or all discs. Press REPEAT once to play a specific track on a particular disc over and over. With this mode selected, the CD player plays the selected disc repeatedly from start to finish. Selecting this mode sets the init playing all loaded discs repeatedly. Playing the Program To play your programmed tracks, press PROGRAM then PLAY/PAUSE. Repeating a Program When you program tracks into memory, you can repeat playing the program by pressing REPEAT after the program begins playing. Clearing the Program You cannot select tracks within a program to clear. Upon completion of the following steps, the entire program will be cleared. If the program is already empty, EMPTY will show in the display. Playing and Loading Discs Simultaneously You can open the CD compartment tray without interrupting the playing music. While the disc is playing, you can change the rest of the four discs by pressing DISC SKIP to rotate the tray clockwise and anti-clockwise to load 8 RP8070 IB rev3 9 8/14/01, 4:59 PM Using the CD Player EN ALL DISCS 1 5 ATS 2 6 3 7 4 8 5 4 1 DISC 2 9 10 11 12 13 14 15 3 Fig. 3 Using Auto Track Skip (ATS) ATS is the opposite of programmed play. Rather than programming into memory the tracks that you want to hear, with ATS you set the unit to skip those tracks that you don't like. Clearing the ATS Program Clearing the ATS program is also a lot like clearing a regular program. Press and hold CLEAR until CLEAR shows on the display. Creating an ATS Program 1. Press PLAY/PAUSE to begin playing the ATS program. Recalling and Editing the ATS Program Editing the ATS program is a lot like editing a regular program. Press PROGRAM to move to the next program number unitl you get to the programmed track you want to change. [. . . ] · This warranty gives you specific legal rights, and you also may have other rights that vary from state to state. If you purchased your unit outside the United States: · This warranty does not apply. Contact your dealer for warranty information. EN Service calls which do not involve defective materials or workmanship are not covered by this warranty. Costs of such service calls are the sole responsibility of the purchaser. 15 RP8070 IB rev3 16 8/14/01, 5:01 PM Limited Warranty (For Canada) EN What your warranty covers: · Defects in materials or workmanship. [. . . ]