User manual REVEL C10 REV 0

[. . . ] Optimum performance is dependent upon following these instructions, as well as those in the owner's manuals of associated components in your home theater system. Save these instructions for future reference. Planning Your System Before deciding where to best place your speakers, survey your room and study Figure 1. Center Channel (above or below video screen) Left Front Channel (not included) Right Subwoofer Front (not included) Channel (not included) Listening Position Left Surround Channel (not included) Right Surround Channel (not included) Unpacking the Speaker Finish unpacking the loudspeaker and check the contents. If you suspect damage from transit, report it immediately to your dealer. [. . . ] Consult the owner's manuals included with your amplifier or receiver for connection and operation procedures. Surround Modes When using the system in a Dolby® Digital or DTS® home theater system, make sure the receiver or processor is set to "Small" for the C10 center channel loudspeaker. When using the C10 in a Dolby Pro Logic® home theater system, make sure the receiver's center channel mode is set to "Normal. " Some receivers/processors offer a choice of crossover frequencies. Select 110Hz as the crossover frequency for the C10 center channel loudspeaker. Some Dolby Digital-equipped receivers/processors offer different setup options for each source or surround mode, e. g. , CD-stereo, DVD, Dolby, Pro Logic. In each case, follow your equipment's instructions to ensure that the subwoofer output is turned on and that the speakers are set to "Small" or to a crossover frequency of 110Hz in each mode. ­ + Figure 4: This example shows how to connect bare wires to the terminals. Banana plugs may also be inserted directly into the rear of the connector. Inset bare ends; tighten terminals. Maintenance and Service When needed, use a soft cloth to remove any fingerprints or to wipe off dust. If your C10 loudspeaker should ever need service, please contact your local dealer or distributor, or visit www. revelspeakers. com for the location of a Wiring and Polarity The C10 speaker has gold-plated terminals that can accept bare wire. To ensure proper polarity, connect each + terminal on the back of the amplifier or receiver to the respective + (red) terminal on each speaker, as shown in Figure 4. See the owner's manuals that were included with your amplifier or receiver to confirm connection procedures. DO NOT reverse polarities (+ to ­ or ­ to +) when making connections. Doing so will degrade the imaging and bass response of the home theater system. After correctly placing and wiring the C10 and the rest of your speaker system, adjust the levels for all of the channels as recommended by the manufacturer of your receiver/processor. 6 Specifications Revel® ConcertaTM C10 Frequency Response (±3dB) Recommended Amplifier Power Range Sensitivity (2. 83V @ 1m, 2 anechoic) Nominal Impedance Crossover Frequency Low-Frequency Drivers LF Extension Mid-Frequency Drivers High-Frequency Driver External Dimensions (H x W x D) Weight (Net) 110Hz ­ 21kHz 10 ­ 150 Watts 89dB 8 Ohms 2­1/2-Way high-order at 400Hz and 2. 2kHz Dual 3" (76mm) woofers with Micro Ceramic Composite (MCC) cones ­3dB @ 110Hz, ­6dB @ 100Hz, ­10dB @ 80Hz Dual 3" (76mm) midrange transducers with Micro Ceramic Composite (MCC) cones 1" (25mm) tweeter with waveguide and Micro Ceramic Composite (MCC) dome 4-1/4" x 22-15/16" x 4-1/2" (107mm x 582mm x 113mm) 6. 75 lb (3. 1kg) 4. 24 22. 90 4. 49 Declaration of Conformity We, Harman Consumer Group, Inc. 2, route de Tours 72500 Château du Loir France declare in own responsibility that the product described in this owner's manual is in compliance with technical standards: 22. 6 1. 8 EN 61000-6-3:2001 EN 61000-6-1:2001 . 75 2. 64 9. 15 4. 32 Laurent Rault Harman Consumer Group, Inc. Château du Loir, France 8/08 7 Limited Warranty service center. This Revel warranty protects the original retail purchaser for a period of five (5) years (parts and labor) from any failure as a result of original manufacturing defects, so long as: 1. The Revel products were purchased within the 50 United States, its territories or Canada. [. . . ] This warranty is applicable in the United States, its territories and Canada. Outside of the United States, its territories and Canada, please contact an authorized Revel dealer for warranty and service information. The information this document contains is subject to change without notice. [. . . ]