Detailed instructions for use are in the User's Guide.
[. . . ] Owner's Manual
Owner's Manual
Deutsch Nederlands Português Español Italiano Français
Bedienungsanleitung
Mode d'emploi
Manuale dell'utente
Manual del usuario
Manual do proprietário
Gebruikershandleiding
English
Owner's Manual
High quality portable stereo-output amp
English Nederlands Português Español Italiano Français Deutsch
The BA-330 is a portable amp that provides stereo playback from a single unit. It's designed for high-quality sound, featuring up to 30W (15W + 15W) of output, four 6. 5 inch (16 cm) speakers and two tweeters.
Take it anywhere Dual power supply (batteries or AC adaptor) for any location p.
You can run the BA-330 on batteries in an outdoor situation where there's no AC outlet, or use the included AC adaptor indoors when AC power is available. 10
You can switch to a power-saving mode that reduces the maximum 30W output to 15W. [. . . ] A brief interval (a few seconds) after power up is required before the unit will operate normally. * Always make sure to have the volume level turned down before switching on power. Even with the volume all the way down, you may still hear some sound when the power is switched on, but this is normal, and does not indicate a malfunction.
Applying an effect
1.
Turn on the [EFFECT] switch for the channels to which you want to apply an effect.
Adjusting the tone quality
Adjusting the tone of each channel Turn the [TONE] knob of the channel that you want to adjust.
.
Turn the [EFFECT] knob to adjust the type and amount of effect.
Adjusting the high and low ranges of the overall sound (Equalizer) Use the [LOW] knob to boost or cut the low-frequency range. Use the [HIGH] knob to boost or cut the high-frequency range.
Example Connections
Sound module
Rhythm Machine
Microphone
Musical instrument (Electric acoustic guitar, etc. )
Musical instrument (Electric acoustic guitar, etc. )
Synthesizer, etc.
PCS-33 PCS-31 or
Red R L R CD player, etc. Mixer, etc.
STEREO LINK OUT STEREO LINK IN
White
L FS-5U
Effect On/Off
FS-5L
Mute On/Off
FS-
Foot switches
Set the FS-5L's or FS-5U's polarity switch as shown below.
When making the connection using the FS-6, set the POLARITY and MODE switches as shown below.
B
A
Other BA-330 * When connection cables with resistors are used, the volume level of equipment connected to the inputs may be low. If this happens, use connection cables that do not contain resistors.
9
Nederlands
Português
Español
Effect On/Off Mute On/Off
Italiano
Français
Deutsch
English
Controls and connectors
Control panel
CH1, CH only (monaural) [MIC/INSTRUMENT] switch
Set this to the appropriate position according to whether a microphone or an instrument (a lineoutput device) is connected to CH1 and CH2. Microphone: Set to "MIC" Instrument: Set to "INSTRUMENT"
CH3/CH, CH5/CH (stereo)
CH3/CH4 and CH5/CH6 are stereo.
CH1, CH only [ANTI-FEEDBACK] switch
Acoustic feedback will be suppressed if this is "ON. " For more about the antifeedback function, refer to "Eliminating feedback" (p. 14).
Connect the following equipment
· · · · · Keyboards Line-level devices Guitars CD players Portable audio players, etc.
CH1, CH (monaural) CH3/CH, CH5/CH (stereo) [TONE] knob
This adjusts the tone of the instrument connected to each channel. Turning the knob toward the right makes the tone brighter.
Power supply related [BATTERY CHECK/MUTE] switch
When switched on, the indicator blinks, and sound will no longer be produced from the BA-330's speakers or from LINE OUT.
[EFFECT] switch
Turning this "ON" allows the reverb, delay, or wide effect to be applied to the channel.
BATTERY indicator
When you press the [CHECK/MUTE] switch, this indicator shows the amount of power remaining in the batteries. * The remaining battery power indication is only an approximation.
CH [VOLUME] knob
This adjusts the volume of the device connected to each channel. * The level knobs of unused channels should be set to "0. "
Full charge
Light Blink Light out
Low charge Please insert new batteries.
Internal speakers overall [EFFECT] knob
This knob selects the effect type and adjusts its depth for channels whose [EFFECT] switch is "ON. "
EQUALIZER
This lets you adjust the tone by boosting or cutting the low and high ranges independently.
[OUTPUT POWER] switch
If this is set to "ECO, " the volume from the BA-330's speakers will be reduced, allowing extended use when running on batteries. With the "ECO" setting, the maximum output will be 15W.
Effect type
REVERB This produces the pleasant reverberation that accompanies a performance in a concert hall. WIDE This extends the sound field to the outer edge of the speakers, producing the sensation of being surrounded by sound.
[LOW] knob
This adjusts the low-frequency tone.
[HIGH] knob
This adjusts the high-frequency tone.
[POWER] switch
This turns the BA-330's power on/off. When this is on, the POWER indicator will light.
MASTER [VOLUME] knob
This adjusts the overall volume of the output from the BA-330's speakers.
10
Controls and connectors
Jack panel
Input (INPUT) jacks CH1, CH: monaural Connect the following equipment
· Microphone · Musical instrument (Guitar, etc. ) If something is connected to both the XLR connector and phone connector at the same time, the phone jack will be given priority. Make connections after first checking the wiring diagrams of other equipment you intend to connect.
TIP HOT RING COLD SLEEVE GND HOT COLD GND
Input (INPUT) jack CH3/CH: stereo CH5/CH: stereo Connect the following equipment
· · · · · Keyboards Line-level devices Guitar CD player Portable audio player, etc.
If you're using a monaural source, connect it to L/MONO (CH4 or CH6).
Width: 144 mm Depth: 22 mm
Input (AUX IN) jack
Deutsch Nederlands Português Español
These jacks are used when you want to connect two BA-330 units to create a stereo system with greater output power. For details, refer to "Connecting an additional unit to increase the output (Stereo Link)" (p. You can use a foot switch to turn MUTE (FS-5L) and EFFECT (FS-5U) on/off. The EQUALIZER knobs and the MASTER [VOLUME] knob do not affect the LINE OUT jacks. If only one foot switch is connected using a monaural cable, only the MUTE function can be switched.
AC adaptor (DC IN) jack
Connect the following equipment
Français
· CD player · Portable audio player, etc. * You can also connect the commercially available cable for an external power device.
Stereo link (STEREO LINK) jacks
Output (LINE OUT) jacks
FOOT SW jack
11
Italiano
English
You can place your portable audio player here.
* This will accommodate a player of up to the following size.
Various Applications
Mini-concert with two guitarists
Using just a single BA-330, two singer-instrumentalists can connect two microphones and two guitars, and perform a mini-concert. You can also apply reverb to the microphones and guitars.
Microphone 1
Microphone
Connection
Microphone 1 Microphone Guitar 1 Guitar
Guitar 1
Guitar
Try it out Apply reverb to the microphones and guitars
1. .
BA-330
Turn the [EFFECT] switch "ON. " Use the [EFFECT] knob to adjust the amount of reverb.
Range of reverb
Lecture or presentation
You can connect your computer as well as your microphone so that the sound from your computer will also be heard by the audience, making your presentation more effective.
Connection
Microphone
Computer
Microphone Computer BA-330
1
Various Applications
Vocalist with keyboard
You can connect your keyboard in stereo, and sing and play along with an accompaniment provided from your portable audio player. [. . . ] Manduvira Asuncion PARAGUAY TEL: (595) 21 492147
KOREA
Cosmos Corporation 1461-9, Seocho-Dong, Seocho Ku, Seoul, KOREA TEL: (02) 3486-8855
HUNGARY
Roland East Europe Ltd. Warehouse Area `DEPO' Pf. 83 H-2046 Torokbalint, HUNGARY TEL: (23) 511011
COLOMBIA
Centro Musical Ltda. Cra 43 B No 25 A 41 Bododega 9 Medellin, Colombia TEL: (574)3812529
MALAYSIA
Roland Asia Paci c Sdn. 45-1, Block C2, Jalan PJU 1/39, Dataran Prima, 47301 Petaling Jaya, Selangor, MALAYSIA TEL: (03) 7805-3263
PERU
Audionet Distribuciones Musicales SAC Juan Fanning 530 Mira ores Lima - Peru TEL: (511) 4461388
IRAN
MOCO INC. [. . . ]