User manual ROLAND GR-33 MANUAL 2
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ROLAND GR-33. We hope that this ROLAND GR-33 user guide will be useful to you.
You may also download the following manuals related to this product:
ROLAND GR-33 (3141 ko)
ROLAND GR-33 (1654 ko)
ROLAND GR-33 (2005 ko)
ROLAND GR-33 WAS IST NEU (22 ko)
ROLAND GR-33 KURZANLEITUNG (25 ko)
Manual abstract: user guide ROLAND GR-33MANUAL 2
Detailed instructions for use are in the User's Guide.
[. . . ] Owner's Manual
Thank you, and congratulations on your choice of the Roland GR-33 Guitar Synthesizer. Before using this unit, carefully read the sections entitled: · USING THE UNIT SAFELY (page 23) · IMPORTANT NOTES (page 9) These sections provide important information concerning the proper operation of the unit. Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Owner's manual should be read in its entirety. The manual should be saved and kept on hand as a convenient reference.
Copyright © 2000 ROLAND CORPORATION All rights reserved. [. . . ] This effect is most effective on organ-type Patches.
fig. 6-12
LOW GAIN -15+15 dB
Specify the low frequency gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the low frequency range.
L in
HIGH GAIN -15+15 dB
Specify the high frequency gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the high frequency range.
R in
L out Rotary R out
LEVEL (Output level) 0127
Specify the output volume.
HIGH SLOW (High frequency slow rate) 0. 0510. 0 Hz
Specify the low-speed (SLOW) rotational speed of the highrange rotor.
57
Chapter 6 Using the Built-in Effects
LOW SLOW (Low frequency slow rate) 0. 0510. 0 Hz
Specify the low-speed (SLOW) rotational speed of the lowrange rotor.
9: COMPRESSOR
Compressor is an effect which restricts high sound levels and boosts low sound levels, thus smoothing out variations in volume.
fig. 6-13
L in
HIGH FAST (High frequency fast rate) 0. 0510. 0 Hz
Specify the high-speed (FAST) rotational speed of the highrange rotor.
R in
L out Compressor 2-Band EQ
Pan L Pan R
R out
SUSTAIN 0127
Specify the time over which low-level sounds are boosted to a constant volume level.
LOW FAST (Low frequency fast rate) 0. 0510. 0 Hz
Specify the high-speed (FAST) rotational speed of the lowrange rotor.
ATTACK 0127
Specify the attack time of the input sound.
SPEED Slow/Fast #
Select the rotational speed of the low-range rotor and highrange rotor. Slow: The specified rotational speeds (the LOW SLOW RATE/ HI SLOW RATE values) will take effect. Fast: The specified rotational speeds (the LOW FAST RATE/ HI FAST RATE values) will take effect.
PAN (Output pan) L640R63
Specify the stereo location of the output sound. A setting of L64 is far left, 0 is center, and R63 is far right.
POST GAIN 0/+6/+12/+18 dB
Specify the output level.
LOW GAIN -15+15 dB
Specify the low frequency range gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the low frequency range.
HIGH ACCL (High frequency acceleration) 015
Specify the time required for the rotational speed of the highrange rotor to change from the low speed to the high speed (or from the high speed to the low speed). More time will be required as the value of this parameter is decreased.
HIGH GAIN -15+15 dB
Specify the high frequency range gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the high frequency range.
LOW ACCL (Low frequency acceleration) 015
Specify the time required for the rotational speed of the lowrange rotor to change from the low speed to the high speed (or from the high speed to the low speed). More time will be required as the value of this parameter is decreased.
LEVEL (Output level) 0127 #
Specify the output volume.
HIGH LEVEL (High frequency level) 0127
Specify the volume of the high-range rotor.
10: LIMITER
Limiter is an effect which compresses sounds that are louder than a specified volume level, preventing distortion from occurring.
fig. 6-14
LOW LEVEL (Low frequency level) 0127
Specify the volume of the low-range rotor.
L in Limiter R in 2-Band EQ
L out
Pan L Pan R
SEPARATION 0127
Specify the spaciousness of the sound.
R out
LEVEL (Output level) 0127
Specify the output volume.
THRESHOLD (Threshold level) 0127
Specify the volume level at which compression will begin.
RELEASE (Release time) 0127
Specify the time from when the volume falls below the threshold level until the limiter effect no longer applies.
RATIO (Compression ratio) 1. 5:1/2:1/4:1/100:1
Specify the compression ratio.
58
Chapter 6 Using the Built-in Effects
PAN (Output pan) L640R63
Specify the stereo location of the output sound. A setting of L64 is far left, 0 is center, and R63 is far right.
PAN DEV (Pan deviation) 020
Specify the difference in stereo position between each of the chorus sounds. With a setting of 0, all of the chorus sounds will be panned to the center. Setting this to 20 provides the greatest breadth.
POST GAIN 0/+6/+12/+18 dB
Specify the level of the output sound.
BALANCE (Effect balance) D100:0ED0:100E LOW GAIN -15+15 dB
Specify the gain (amount of boost or cut) for the low frequency range. Specify the volume balance between the original sound and the chorus sound. With a setting of D100:0E only the original sound will be output, and with a setting of D0:100E only the chorus sound will be output.
HIGH GAIN -15+15 dB
Specify the gain (amount of boost or cut) for the high frequency range. Positive (+) settings will emphasize (boost) the high frequency range.
LEVEL (Output level) 0127
Specify the output volume.
12: TREMOLO-CHO (Tremolo Chorus)
Tremolo-chorus is a chorus with a tremolo effect (cyclic modulation of volume).
fig. 6-16
LEVEL (Output level) 0127 #
Specify the output volume.
L in
Balance D
L out
Balance E
11: HEXA-CHORUS
Hexa-chorus is a six-stage chorus which adds depth and spaciousness to the sound. (Six chorus sounds with different delay times are overlaid. )
fig. 6-15
Tremolo Chorus
Balance E
R in
Balance D
R out
Chap. 6
L in
Balance D
L out
Balance E
PRE DELAY (Pre delay time) 0. 0100 ms
Specify the delay time from the original sound until when the chorus sound is heard.
Hexa Chorus
Balance E
CHORUS RATE 0. 0510. 0 Hz
Specify the modulation frequency of the chorus sound.
R in
Balance D
R out
PRE DELAY (Pre delay time) 0. 0100 ms
Specify the delay time from the original sound until when the chorus sound is heard.
CHORUS DEPTH 0127
Specify the modulation depth of the chorus sound.
TREM RATE (Tremolo rate) 0. 0510. 0 Hz #
Specify the modulation frequency of the tremolo effect.
RATE 0. 0510. 0 Hz #
Specify the modulation frequency of the chorus sound.
TREM SEP (Tremolo separation) 0127
Specify the spaciousness of the tremolo effect.
DEPTH 0127
Specify the modulation depth of the chorus sound.
TREM PHASE (Tremolo phase) 0180
Adjusts the phase of the tremolo effect.
PRE DLY DEV (Pre delay deviation) 020
The Pre Delay parameter explained above specified the delay time from the original sound until when the chorus sound is heard. This Pre Delay Deviation parameter specifies the differences in Pre Delay time for each of the chorus sounds. Higher settings will cause each of the chorus sounds to be spread further apart.
BALANCE (Effect balance) D100:0ED0:100E
Specify the volume balance between the original sound and the tremolo-chorus sound. With a setting of D100:0E only the original sound will be output, and with a setting of D0:100E only the tremolochorus sound will be output.
DEPTH DEV (Depth deviation) -20+20
Specify the difference in modulation depth between each of the chorus sounds.
LEVEL (Output level) 0127
Specify the output volume.
59
Chapter 6 Using the Built-in Effects
13: SPACE-D
Space-D is a multiple chorus that applies two-stage modulation in stereo. It does not produce a sense of modulation, but creates a transparent chorus effect.
fig. 6-17
FILTER TYPE Off/LPF/HPF
Select the type of filter. LPF:
2-Band EQ
Balance E Balance E
Balance D
L in Space D Space D R in
Balance D
L out
The frequency region above the Cutoff Freq setting will be cut. [. . . ] Eden, Auckland 3, NEW ZEALAND TEL: (09) 3098 715
EUROPE
AUSTRIA
Roland Austria GES. M. B. H.
Siemensstrasse 4, P. O. Box 74, A-6063 RUM, AUSTRIA TEL: (0512) 26 44 260
SPAIN
Roland Electronics de España, S. A.
Calle Bolivia 239, 08020 Barcelona, SPAIN TEL: (93) 308 1000
TURKEY
Barkat muzik aletleri ithalat ve ihracat Ltd Sti
Siraselviler cad. Guney is hani 8486/6, Taksim. TURKEY TEL: (0212) 2499324
CENTRAL/LATIN AMERICA
ARGENTINA
Instrumentos Musicales S. A.
Florida 656 2nd Floor Office Number 206A Buenos Aires ARGENTINA, CP1005 TEL: (54-11) 4- 393-6057
BELGIUM/HOLLAND/ LUXEMBOURG
Roland Benelux N. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE ROLAND GR-33
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ROLAND GR-33 will begin.