User manual ROLAND GT-10
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ROLAND GT-10. We hope that this ROLAND GT-10 user guide will be useful to you.
You may also download the following manuals related to this product:
ROLAND GT-10 (801 ko)
ROLAND GT-10 (17187 ko)
ROLAND GT-10 (18147 ko)
ROLAND GT-10 (16353 ko)
ROLAND GT-10 annexe 2 (267 ko)
ROLAND GT-10 annexe 1 (17887 ko)
ROLAND GT-10 KURZANLEITUNG (172 ko)
ROLAND GT-10 PRESET PATCH LIST (224 ko)
Manual abstract: user guide ROLAND GT-10
Detailed instructions for use are in the User's Guide.
[. . . ] Owner's Manual
Thank you, and congratulations on your choice of the BOSS GT-10.
201b
Before using this unit, carefully read the sections entitled: "USING THE UNIT SAFELY" (p. These sections provide important information concerning the proper operation of the unit. Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Owner's manual should be read in its entirety. The manual should be saved and kept on hand as a convenient reference.
202
Copyright © 2008 BOSS CORPORATION All rights reserved. [. . . ] 0100 * Be careful not to raise the Level setting too high.
Bright
Turns the bright setting on/off.
The BRIGHT parameter setting is only partially available with some JC CLEAN, TW CLEAN, CRUNCH, or BG LEAD settings in Preamp Type.
Off On
Bright is not used. Provides for selection from three levels of distortion: LOW, MIDDLE, and HIGH. Distortion will successively increase for settings of LOW, MIDDLE and HIGH. * The sound of each Type is created on the basis that the Gain is set to MIDDLE. So, normally set it to MIDDLE.
Gain Sw
Low, Middle, High
Solo Sw
Chapter 8
Off, On
Solo Sw is switched on to create the tone to one suitable for solos. Adjusts the volume level when the Solo Sw is ON.
SoloLevel
0100
SP Type (Speaker Type)
Select the speaker type. This is the built-in speaker of the amp you selected with PREAMP TYPE.
99
Chapter 8 Parameters Guide
Parameter/ Range
1x8" 1x10" 1x12" 2x12" 4x10"
Explanation
This is a compact open-back speaker cabinet with one 8-inch speaker. This is a general open-back speaker cabinet with two 12-inch speakers. This is an optimal speaker cabinet for a large enclosed amp with four 10-inch speakers. This is an optimal speaker cabinet for a large enclosed amp with four 12-inch speakers. This is a double stack of two cabinets, each with four 12-inch speakers. Custom speaker You can customize it however you like to match the sound you want.
Custom
Parameter/ Range Explanation
CUSTOM AMP SETTING
Setting available when Type is set to Custom.
Type
Selects the basic type of preamp. JC Clean TW Clean Crunch VO Drive BG Lead MS HiGain Modern Stk This is the sound of the Roland JC-120. Models the sound of the Channel 2 MODERN Mode on the MESA/Boogie DUAL Rectifier. This controls the input sound's low-frequency range and adjusts the amount of distortion in the low-frequency range. This controls the input sound's high-frequency range and adjusts the amount of distortion in the high-frequency range. Adjusts the preamp section's high-frequency tone.
4x12" 8x12" Custom
Mic Type
This setting selects the simulated mic type. Produces a sonic image close to that of listening to the sound directly from the speakers (on site).
Bottom
-50+50
DYN421
Edge
-50+50
CND451 CND87
Bass Freq (Bass Frequency)
-50+50
Tre Freq (Treble Frequency)
-50+50
FLAT
Mic Dis (Mic Distance)
Simulates the distance between the mic and speaker. Provides conditions whereby the mic is directed more towards the speaker.
PreampLow
-50+50
Preamp Hi (Preamp High)
-50+50
Mic Pos. Center 110cm Simulates the condition that the mic is set in the middle of the speaker cone. Simulates the condition that the mic is moved away from the center of the speaker cone. Adjusts the volume of the direct sound.
Mic Level
0100 0100
DirectLev (Direct Level)
100
Chapter 8 Parameters Guide
Parameter/ Range
Explanation
EQ (Equalizer)
This adjusts the tone as a equalizer. [. . . ] 90 User Bank . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 User Patch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29, 43 User Phrase . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 112 User Quick Setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE ROLAND GT-10
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ROLAND GT-10 will begin.