User manual ROLLS MP110

[. . . ] SPECIFICATIONS Frequency Response THD: EIN (SMPTE): Attenuation: Noise Floor: Connectors: Input Impedance: Output Impedance: Maximum Input Level: Max Output Level: Maximum Gain: Size (WxHxD) Weight: Power: 20Hz - 40kHz, +/- 3dB Mic/Line 5Hz - 40kHz inst. . 1% typical -129 dB 20 dB -90dB XLR balanced and 1/4" unbalanced In and Out 600 balanced, 10M line 100 bal. , and unbal. [. . . ] IN NO EVENT SHALL WE BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED, WHATSOEVER. Some states do not allow the exclusion or limitation of special, incidental or consequential damages so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. 20 dB PAD PHANTOM PWR +17 GAIN +75 -O 0 O VOLUME PHASE REVERSE MP110 OWNERS MANUAL Bellari is a division of ROLLS Corporation Salt Lake City, UT Thank you for your purchase of the Bellari MP110 DIRECT DRIVE Tube Mic Preamp. We recommend that you take a moment and read this manual as it provides information that will help you in using your unit to it's fullest potential. The MP110 provides clear sonic quality and performance for the working musician, studio operator or anyone who needs a preamp with the warm, smooth, analog sound. The unit uses a premium 7025 tube in a unique configuration to give smooth controllable gain. The unit has both XLR and 1/4" inputs and outputs with a 20 dB Pad and a Phase Reversal switch to adapt to any performing or studio situation. Unpack and Inspect the MP110 package Your MP110 was carefully packed at the factory in a protective carton. Nonetheless, be sure to examine the unit and the carton for any signs of damage that may have occurred during shipping. If obvious physical damage is noticed, contact the carrier immediately to make a damage claim. We suggest saving the shipping carton and packing materials for safely transporting the unit in the future. FRONT PANEL DESCRIPTION Tube Mic Preamp CLIP PWR REAR PANEL DESCRIPTION MODEL MP110 MADE IN USA INST. INPUT 12 VAC 300mA OUTPUT CORPORATI ON SERIAL NUMBER 110MIC/LINE INPUT INPUT: 1/4" unbalanced and XLR balanced jacks for receiving incoming signals. OUTPUT: 1/4" unbalanced and XLR balanced jacks for sending outputting the signal to a recording device, mixer, amplifier, etc. [. . . ] This will cause a more harsh distortion than that of overdriving the tube circuit. This may or may not be a desired effect. 1 2 3 4 5 6 7 8 REWIND FAST FWD STOP PLAY RECORD EJECT [. . . ]