User manual ROLLS MS20

[. . . ] LIMITED WARRANTY This product is warranted to the original consumer purchaser to be free from defects in materials and workmanship under normal installation, use and service for a period of one (1) year from the date of purchase as shown on the purchaser's receipt. The obligation of Rolls Corporation under this warranty shall be limited to repair or replacement (at our option), during the warranty period of any part which proves defective in material or workmanship under normal installation, use and service, provided the product is returned to Rolls Corporation, TRANSPORTATION CHARGES PREPAID. [. . . ] Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. IN NO EVENT SHALL WE BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED, WHATSOEVER. Some states do not allow the exclusion or limitation of special, incidental or consequential damages so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. MS20 Mic Splitter LIFT GROUND INPUT OUTPUT MIC SPLITTER MS20 THRU OUTPUT OWNERS MANUAL Rolls Corporation Salt Lake City, UT 3/97 Thank you for your purchase of the MS20 Mic Splitter. This unit was designed to produce two balanced XLR signals, one direct - one transformer isolated, from one single XLR input signal. A ground lift switch has been provided to elliminate some cases of hum caused by ground loops. Unpack and Inspect the MS20 package Your MS20 was carefully packed at the factory in a protective carton. Nonetheless, be sure to examine the unit and the carton for any signs of damage that may have occurred during shipping. If obvious physical damage is noticed, contact the carrier immediately to make a damage claim. We suggest saving the shipping carton and packing materials for safely transporting the unit in the future. [. . . ] GROUND LIFT: Switch when in "GROUND" position, indicates that pins 1 of the INPUT and OUTPUT jacks are connected. In the "LIFT" position, the grounds have been separated. LIFT GROUND INPUT OPERATION Shown below is an example of how to connect your MS20. LIFT GROUND INPUT TO MONITOR BOARD OUTPUT MIC SPLITTER MS20 THRU OUTPUT TO MIXER OUTPUT MIC SPLITTER MS20 SPECIFICATIONS Input Impedance: Output Impedance: Dimensions: Weight: THRU OUTPUT 600 600 3 x 2. 25 x 1. 2 inches 8 Ounces [. . . ]