User manual ROLLS MX34B

[. . . ] For warranty registration please visit the rolls web site at www. rolls. com. MX34b LiveMix HEADSET MIC 1/8" b LiveMix Two Channel Stereo Microphone Mixer/ Headset Mixer MX34b MADE IN USA www. rolls. com ROLLS CORPORATION SALT LAKE CITY, UTAH 09/08 QUICK START OPERATION GUIDE INTRODUCTION Thank you for purchasing the new MX34b LiveMix - two channel microphone mixer. Although having many uses, this little mixer was originally designed with the video camera operator in mind. [. . . ] TABLE OF CONTENTS INTRODUCTION INSPECTION TABLE OF CONTENTS DESCRIPTION Front Panel Rear Panel Battery Installation Phantom Power 1 1 1 2 Size: Weight: CONNECTION 3 A note on wiring a mono signal to the stereo AUX IN OPERATION SCHEMATIC SPECIFICATIONS WARRANTY 4 5 6 BACK COVER 1 6 SCHEMATIC FRONT PANEL HEADSET MIC 1/8" DESCRIPTION b MIC1 and MIC2 LEVEL: Adjusts the amount of signal of the indicated Microphone channel. PAN: Adjusts the relative level of signal from the channel to the Right/Left Output. HEADPHONE LEVEL: Adjusts the amount of signal from the Headphone Output. OUTPUT: 1/8" (3. 5mm) jack containing the Headphone Output signal. REAR PANEL INPUTS: 1 - 2: XLR balanced inputs for connection to any standard dynamic or condenser microphone. The input circuitry has a very wide input range and can accomodate almost any (mic to line) level signal. AUX IN: Tip-Ring-Sleeve stereo 1/8" (3. 5mm) jack for connecting to another line-level stereo signal source. STEREO OUT: Tip-Ring-Sleeve stereo 1/8" (3. 5mm) jack for connection to a camera or other stereo input (Line-level only). BATTERY INSTALLATION: To replace the 9 V alkaline batteries, first carefully press in and up on the door to release the battery compartment. PHANTOM POWER: The Phantom Power jumpers are set to the off position from the factory. To engage the phantom power, first make sure the MX34b is powered off, use a pair of needle-nose pliers or tweezers and carefully pull out the jumper corresponding to the channel you wish to power. 5 2 CONNECTION Connect microphones to the MX34b via balanced XLR cables. Stereo auxiliary sources such as the output from another mixer, AM/FM tuners, CD Players, and MP3 players may be connected to the AUX IN via a stereo 1/8" (3. 5mm) Tip-Ring-Sleeve plug. Connect the STEREO OUT to the Input of your recording device also using a stereo 1/8" (3. 5mm) Tip-Ring-Sleeve plug. [. . . ] DO- TIP RINGPLUG STEREO ING SO WILL RESULT IN SIGNAL LOSS OR DAMAGE TO THE MX34b. If you need to connect a MONO signal (like the output of a wireless microphone) to the AUX IN of the MX34b, you will need to make or purchase a MONO TO STEREO cable. Shown Tip and Ring are wired together, here is a diagram of this cable's wiring. 3 then connected to the Tip of the Mono Plug. 4 [. . . ]