User manual ROLLS RDB109

[. . . ] LIMITED WARRANTY This product is warranted to the original consumer purchaser to be free from defects in materials and workmanship under normal installation, use and service for a period of one (1) year from the date of purchase as shown on the purchaser's receipt. The obligation of Rolls Corporation under this warranty shall be limited to repair or replacement (at our option), during the warranty period of any part which proves defective in material or workmanship under normal installation, use and service, provided the product is returned to Rolls Corporation, TRANSPORTATION CHARGES PREPAID. [. . . ] IN NO EVENT SHALL WE BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED, WHATSOEVER. Some states do not allow the exclusion or limitation of special, incidental or consequential damages so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. RDB109 SOUND CENTER Audio Distribution RDB109 R ROLLS CORPORATION SALT LAKE CITY, UTAH 8/02 OWNERS MANUAL INTRODUCTION Thank you for your purchase of the ROLLS RDB109 SOUND CENTER. The RDB109 is an audio distribution device with a single balanced XLR line-level input, distributed via transformer isolation to ten balanced XLR outputs. The RDB109 may be combined with a Rolls MP13 Mic Preamp, CL151 Mic Preamp/ Compressor Limiter, or DU30 Mic Preamp/Ducker for clear microphone access to the RDB109. OPERATION Connect the input source to the INPUT of the RDB109. We do not recommend connecting a microphone directly into the RDB109 INPUT. Connect the RDB109 OUTPUTs to the inputs of the recording, broadcasting, etc. devices. NOTE: This manual assumes the user has a basic working knowledge of the proper connection and operation of professional audio equipment. DESCRIPTION FRONT PANEL OPERATING WITH A ROLLS MIC PREAMP ACCESSORY Remove the docking bay filler panel by removing the two screws located directly under the docking bay on the bottom of the RDB109. Line up the holes in the bottom of the Rolls Mic Preamp accessory with those on the bottom of the RDB109. Secure the accessory to the RDB109 with the two screws that were removed from the filler panel. NOTE: The other accessories require a special cable or adapter as they do not have XLR outputs. The CL151 GLC has a 1/4" TRS output that is easily connected to an XLR plug. [. . . ] SPECIFICATIONS Connectors: 0 -10 0 -20 +12 -10 0 0 +10 - +20 -30 off -30 +10 -10 +20 RDB109 Fig. 1 1 XLR Female Input Jack 1 XLR Male Loop Through Jack 10 XLR Male Output Jacks 30 - 20kHz +0 /- 3 dB 600 9 each 60 9 19" x 1. 75" x 2. 5" (480 x 45 x 64 mm) 4 lbs. Frequency Response: Output Impedance: Input Impedance: Size (W x H x D): Weight: MIC IN LINE IN SIDE CHAIN LINE OUT DC IN 12 VDC + PHANTOM POWER off on GLC Gate Limiter Compressor CL151 Fig. [. . . ]