User manual RUSSOUND VBC KIT
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual RUSSOUND VBC KIT. We hope that this RUSSOUND VBC KIT user guide will be useful to you.
Manual abstract: user guide RUSSOUND VBC KIT
Detailed instructions for use are in the User's Guide.
[. . . ] When in doubt, turn off the power at the circuit breaker or fuse and test that the power is turned off. Read Instructions - All the safety and operating instructions should be read before the appliance is operated. Retain Instructions - The safety and operating instructions should be retained for future reference. Heed Warnings - All warnings on the appliance in the operating instructions should be adhered to. [. . . ] Do Not Touch The Unit With Wet Hands Do not handle the unit or power cord when your hands are wet or damp. If water or any other liquid enters the cabinet, take the unit to a qualified service person for inspection.
LIMITED WARRANTY
The Russound CRX and CTX baluns are fully guaranteed for two (2) years from the date of purchase against all defects in materials and workmanship. For this warranty to apply, the unit must be installed and used according to its written instructions. During this period, Russound will replace any defective parts and correct any defect in workmanship without charge for either parts or labor. Accidental damage and shipping damage are not considered defects under the terms of this warranty. Russound assumes no responsibility for defects resulting from abuse or servicing performed by an agency or person not specifically authorized in writing by Russound. Damage to or destruction of components due to excessive power voids the warranty. To return for repairs, the unit must be shipped to Russound at the owner's expense, along with a note explaining the nature of the service required. Be sure to pack in a corrugated container with at least 3 inches of resilient material to protect the unit from damage in transit. Before returning a unit for repair, call Russound at (603) 659-5170 for a Return Authorization number. Write the RA number on the shipping label and ship to: Russound, ATTN: Service, 5 Forbes Road, Newmarket NH 03857 Russound sells product only through authorized Dealers and Distributors to ensure that customers obtain proper support and service. Any Russound product purchased from an unauthorized dealer or other source, including retailers, mail order sellers and online sellers will not be honored or serviced under existing Russound warranty policy. Any sale of products by an unauthorized source or other manner not authorized by Russound shall void the warranty on the applicable product.
VBC Kit
Composite A/V Balun Installation Manual
INTRODUCTION
The VBC Composite Audio Video Balun Kit contains a pair of active circuitry (powered) baluns for sending composite video and two-channel analog audio over a single CAT-5 cable. This kit includes a transmitter and receiver and would be used in multiroom audio-video distribution systems to remotely locate an audio-video source from a distribution or display device. The benefits of using this kit are that it uses low-cost CAT-5 cable, plus it eliminates ground loops, which may occur when remotely locating sources from displays. Ground loops are seen as lateral "hum" bars scrolling on the display and an audible hum in the audio. The kit also uses an active buffer switch that allows a source signal to be split and shared with another system.
KIT CONTENTS
5 Forbes Rd. Newmarket, NH 03857 Tel 603. 659. 5170 · Fax 603. 659. 5388 e-mail: tech@russound. com 28-1246 01/24/06
(1) CTX transmitter module (1) CRX receiver module (1) 846C 12VDC 200mA power supply
INSTALLATION
You will need two sets of RCA cables and the appropriate length of CAT-5 cable. [. . . ] For the CAT-5 connection, use a CAT-5 patch cable with RJ45 connections at each end using the T568A wire configuration. Run CAT-5 cable from the back of the wall plate to the back of the wall plate located near the remote display.
At the RECEIVE end: The CRX is located at the remote end (TV, VCR, stereo, etc. ) of the system. Use an RCA audio-video cable and connect the appropriate audio-video inputs of the equipment to the CRX unit's Right, Left and Video inputs. If the source audio is mono, connect the Left connector only (leave Right unconnected). [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE RUSSOUND VBC KIT
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual RUSSOUND VBC KIT will begin.