User manual SCHOLTES TIS 621 CT L

[. . . ] Switching on the hob Switching on the cooking zones Medium function Booster function Switching off the cooking zones Programming the cooking duration Timer Control panel lock Switching off the hob "Demo" mode EXTENSO TECHNOLOGY mode Practical advice on using the appliance Safety devices Practical cooking advice Before operating your new appliance please read this instruction booklet carefully. The appliance must be installed by a qualified professional in accordance with the instructions provided. Incorrect installation may cause harm to people and animals or may damage property. If the appliance is to be installed above an oven, the oven must be equipped with a forced ventilation cooling system. [. . . ] All the cooking zones may be programmed simultaneously, for a duration between 1 and 99 minutes. When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children, during cleaning, etc. Press the button to lock the control panel: the indicator light above the button will switch on. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. A buzzer sounds for approximately 1 minute and the cooking zone switches off when the set programme has finished. If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. To visualise the time remaining for the other programmed hotplates, press the button repeatedly: the time remaining for each hotplate will be shown sequentially in a clockwise order, starting from the front left hotplate. Press the button to switch off the appliance - do not If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the "demo" mode the hob must be switched on, with all the hotplates switched off. When the 6 seconds have elapsed, the ON/OFF and CONTROLS LOCKED indicator lights will flash for one second. At step 2, press the button: the duration decreases progressively until it reaches 0 and switches off. When the hob is switched on again it will be set to the "demo" mode. the display will show the text DE and OF and the hob will be switched off. Use cookware made from materials which are compatible with the induction principle (ferromagnetic material). We especially recommend pans made from: cast iron, coated steel or special stainless steel adapted for induction. The appliance has a safety switch which automatically switches the cooking zones off after they have been in operation for a certain amount of time at a particular power level. The 2 LEDs remain lit as long as the hotplates are linked (if EXTENSO TECHNOLOGY button is pressed again, the hotplates are disconnected and are both set to power level 0). Pressing the +, - or Max buttons for one of the two Flexi hotplates also affects the display corresponding to the other hotplate. A timer may be set for the EXTENSO TECHNOLOGY; this appears on the display and both LEDs corresponding to the linked hotplates light up. [. . . ] To avoid any interference between your induction hob and a pacemaker, the latter must be designed to comply with relevant regulations. Please consult the pacemaker manufacturer or your doctor concerning its conformity or any possible incompatibility. â· The appliance is not intended to be operated by means of an external timer or separate remotecontrol system. When disposing of packaging material: observe local legislation so that the packaging may be reused. [. . . ]