User manual SCHOLTES TIS 744 DD L

[. . . ] Switching on the hob Switching on the cooking zones Medium function Booster function Switching off the cooking zones Programming the cooking duration Timer Control panel lock Switching off the hob "Demo" mode Practical advice on using the appliance Safety devices Practical cooking advice Before operating your new appliance please read this Please keep these operating instructions for future reference. The appliance must be installed by a qualified professional in accordance with the instructions provided. Incorrect installation may cause harm to people and animals or may damage property. If the appliance is to be installed above an oven, the oven must be equipped with a forced ventilation cooling system. [. . . ] If the booster for the rear left-hand hotplate has been activated, the power level of the front left-hand hotplate will be reduced). To switch off the hotplate, select the button corresponding to the desired zone, moving the slider towards the left to return to level 0, or press the Off button on the slider control directly. The first time the slider is pressed, a short beep will sound to acknowledge the touch. If - and only if the power level is adjusted, another short beep will sound when the slider is released. The hotplate selection LEDs light up for the power adjustment period (10 seconds), during which the slider (or min/med/max buttons)* can influence the selected hotplate. Period of time, the timer scrolls quickly through the minute values in the corresponding direction. All the cooking zones may be programmed simultaneously, for a duration between 1 and 99 minutes. When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children, during cleaning, etc. Press the button to lock the control panel: the indicator light above the button will switch on. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. A buzzer sounds for approximately 1 minute and the cooking zone switches off when the set programme has finished. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. To visualise the time remaining for the other programmed hotplates, press the button repeatedly: the time remaining for each hotplate will be shown sequentially in a clockwise order, starting from the front left hotplate. Use the button repeatedly until the duration you buttons to set the new duration. Press the button to switch off the appliance - do not If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the "demo" mode the hob must be switched on, with all the hotplates switched off. At step 2, press the button: the duration decreases progressively until it reaches 0 and switches off. When the 6 seconds have elapsed, the ON/OFF and CONTROLS LOCKED indicator lights will flash for one second. When the hob is switched on again it will be set to the "demo" mode. [. . . ] Please consult the pacemaker manufacturer or your doctor concerning its conformity or any possible incompatibility. â· The appliance is not intended to be operated by means of an external timer or separate remotecontrol system. When disposing of packaging material: observe local legislation so that the packaging may be reused. â· The European Directive 2002/96/EC relating to Waste Electrical and Electronic Equipment (WEEE) states that household appliances should not be disposed of using the normal solid urban waste cycle. [. . . ]