User manual SIEMENS SN24D801EU/10 SHORT INSTRUCTIONS
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SIEMENS SN24D801EU/10. We hope that this SIEMENS SN24D801EU/10 user guide will be useful to you.
Manual abstract: user guide SIEMENS SN24D801EU/10SHORT INSTRUCTIONS
Detailed instructions for use are in the User's Guide.
[. . . ] soft soft medium medium * only before the first wash or if the water hardness has been changed medium hard hard hard Set value
Quickly sorted . . .
How to adjust the water softening system Switch on ON/OFF switch Hold down programme button A and press START button until H:0. . . The LED for button A flashes and the factory set value of H:04 is indicated on the digital display Press programme button C. [. . . ] The chosen setting has now been stored.
ABC
Filling the salt dispenser
Dissolves limescale (not necessary for set value 0 !) . . .
Unscrew cover. Wash immediately.
Adding rinse aid
Spick and span . . .
Press mark 1, lift up cover 2.
Refill if rinse-aid refill indicator is lit!
Adding rinse aid. CLICK!
Adding detergent
A lot of dirt, a lot of detergent . . .
If required, open the cover (press button). Attention Combination products are not suitable for all programmes, follow manufacturer's instructions. PLOP!
Switching on the appliance
Select programme 640 MA
Quick, economical or intensive . . .
Overview of programmes The max. The corresponding programmes for your appliance can be found on the fascia. Install supply hose without kinks.
Display "E:24" and " " is lit
Waste water hose is blocked or kinked Cover not attached to waste water pump
Install waste water hose without kinks. Milky deposits on the utensils (can be removed)
Rinse-aid dosage too high/too low
Streaks: reduce dosage. Water or limescale stains: increase dosage.
Display "E:25" and " " is lit
Waste water pump blocked
Water softening system incorrectly set; No salt Glasses not dishwasher-proof.
Correctly set water softening system. Use a detergent suitable for glasses.
Other fault display "E:XX" is lit
Appliance has technical defect
Call factory customer service (state fault display). Unplug appliance.
Residual water in the appliance
The programme has not yet ended
Close and switch on the appliance or terminate the programme (see Terminating the programme).
Milky deposits, glasses cloudy/tarnished (cannot be removed)
Too little detergent. Hard knife blades are more susceptible Extraneous rust Use dishwasher-proof cutlery. [. . . ] Hard knife blades are more susceptible Extraneous rust Use dishwasher-proof cutlery. Plastic/utensils discoloured Discoloration caused by food colourings (tomato sauce)
Follow manufacturer's instructions (detergent). [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SIEMENS SN24D801EU/10
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SIEMENS SN24D801EU/10 will begin.