User manual SKIL 2230

[. . . ] WARNING and instructions may result in electric shock, fire and/or serious injury. The term "power tool" in all of the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. [. . . ] WARNING when batteries are not in Tool or charger, always place protective cap onto end of battery pack. WARNING semble the battery or remove any component projecting from the battery terminals. Prior to disposal, protect exposed terminals with heavy insulating tape to prevent shorting. NICKEL-CADMIUM BATTERIES If equipped with a nickel-cadmium battery, the battery must be collected, recycled or disposed of in an environ mentally sound manner. "The EPA certified RBRC Battery Recycling Seal on the nickel-cadmium (Ni-Cd) battery indicates Robert Bosch Tool Corporation is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC program provides a convenient alterative to placing used Ni-Cd batteries into the trash or the municipal waste stream, which may be illegal in your area. Please call 1-800-8-BATTERY for information on Ni-Cd battery recycling and disposal bans/restrictions in your area, or return your batteries to a Skil/Bosch/Dremel Service Center for recycling. Robert Bosch Tool Corporation's involvement in this program is part of our commitment to preserving our environment and conserving our natural resources. Proper interpretation of these symbols will allow you to operate the tool better and safer. Rotational speed, at no load Per minute Off position Selector settings Infinitely variable selector with off Arrow Alternating current Direct current Alternating or direct current Class II construction Earthing terminal Warning symbol Ni-Cad RBRC seal Zero speed, zero torque. Higher number means greater speed Speed is increasing from 0 setting Action in the direction of arrow Type or a characteristic of current Type or a characteristic of current Type or a characteristic of current Designates Double Insulated Construction tools. The tool can be turned "ON" or "OFF" by squeezing or releasing the trigger. The speed can be adjusted from the minimum to maximum nameplate RPM by the pressure you apply to the trigger. Apply more pressure to increase the speed and release pressure to decrease speed (Fig. FORWARD/REVERSING LEVER & TRIGGER LOCK After tool use, lock trigger in ! wARNING "OFF" position to help prevent accidental starts and accidental discharge. Your tool is equipped with a forward/ reversing lever and trigger lock located above the trigger (Fig. For forward rotation, (with chuck pointed away from you) move the lever to the far left. Do not CAUTION rotation change direction of until the tool comes Shifting during rotation of the chuck can cause damage to the tool. The drill " " position will lock up the clutch to permit drilling and driving for heavyduty work (Fig. This is especially useful in the repetitive driving and removal of screws. RELEASING AND INSERTING BATTERY PACK Release battery pack from tool by pressing on both sides of the battery release tabs and pull downwards. [. . . ] Apply the brush to the work in such a way that as much of the brush face as possible is in full contact with the work. RUNNING NUTS AND BOLTS Variable speed control must be used with caution for driving nuts and bolts with socket set attach ments. The technique is to start slowly, increasing speed as the nut or bolt runs If this procedure is not followed, the tool will have a tendency to torque or twist in your hands when the nut or bolt seats. Preventive maintenance performed by unauthorized personnel may result in misplacing of internal wires and components which could cause serious hazard. [. . . ]