User manual SKIL 2255

[. . . ] A moment of inattention while operating power tools may result in serious personal injury. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. Ensure the switch is in the off-position before connecting to power source and / or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energizing power tools that have the switch on invites accidents. [. . . ] Use only the charger which accompanied your product or direct replacement as listed in the catalog or this manual. Do not disassemble charger or operate the charger if it has received a sharp blow, been dropped or otherwise damaged in any way. If battery case is cracked or otherwise damaged, do not insert into charger. Other types of batteries may burst causing personal injury and damage. Charge battery pack in temperatures above +32 degrees F (0 degrees C) and below +113 degrees F (45 degrees C). Store tool and battery pack in locations where temperatures will not exceed 120 degrees F (49 degrees C). If liquid comes in contact with skin, wash quickly with soap and water. If the liquid contacts your eyes, flush them with water for a minimum of 10 minutes and seek medical attention. Place charger on flat non-flammable surfaces and away from flammable materials when re-charging battery pack. Carpeting and other heat insulating surfaces block proper air circulation which may cause overheating of the charger and battery pack. If smoke or melting of the case are observed unplug the charger immediately and do not use the battery pack or charger. Rotate the chuck sleeve counterDisconnect battery pack clockwise viewing from chuck end, and open chuck to approximate drill bit diameter. Insert a clean bit up to the drill bit flutes for small bits, or as far as it will go for large bits. Do not use the power of the drill while grasping chuck to loosen or tighten bit. Open the chuck all the way, remove left-hand thread screw inside chuck by turning it clockwise (Fig. Insert the short arm of a 3/8" hex key wrench and close jaws on flats of wrench. Strike long arm of wrench sharply counterclockwise, remove wrench and unthread chuck from spindle. INSTALLING CHUCK Always keep the spindle threads, the threads of the chuck and securing screw free of debris. Protective pack is run-down completely, it may require cap, guards against terminal shorting. If battery does not charge properly: its maximum capacity with its first few charge a. The charger was designed to fast charge light switch which turns power "off" when lights the battery only when the battery temperature are turned off. A substantial drop in operating time per Clean with cotton swab and alcohol if charge may mean that the battery pack is necessary. [. . . ] Safe operating speed is not exceeded by the nameplate speed of the tool. When using polishing bonnets, always be sure the excess string that secures the bonnet is tucked well within the bonnet during operation. Operate the brush with the lightest pressure so only the tips of the wire come in contact with the work. If heavier pressures are used, the wires will be overstressed, resulting in a wiping action; and if this is continued, the life of the brush will be shortened due to wire fatigue. [. . . ]