User manual SKIL 2492

[. . . ] 25 Nm 1 2 3 45 2 C 3 D E F B 4 5 Cd 2 6 77 a b 7 G C 1 2 HIGH SPEED LOW SPEED 7 A 34 5 8 9 0 HSS ! PHILLIPS POZIDRIV SLOTTED ACCESSORIES Battery 12 V (2492) 1, 3 Ah 1, 7 Ah 1, 8 Ah 1, 3 Ah 1, 7 Ah 1, 8 Ah 1, 3 Ah 1, 7 Ah 1, 8 Ah NiCad NiCad NiMH NiCad NiCad NiMH NiCad NiCad NiMH SKIL nr. 2610389464 2610389465 2610388963 2610389467 2610389468 2610388964 2610389470 2610389471 2610388965 Battery 14, 4 V (2592) Battery 18 V (2692) 3 GB INTRODUCTION This tool is intended for drilling in wood, metal, ceramic and plastic; tools with electronic speed control and left/right rotation are also suitable for screwing and thread cutting Do not disassemble charger or battery Do not attempt to recharge non-rechargeable batteries with the charger WHEN CONNECTING NEW 3-PIN PLUG (U. K. ONLY): Do not connect the blue (= neutral) or brown (= live) wire in the cord of the charger to the earth terminal of the plug If for any reason the old plug is cut off the cord of the charger, it must be disposed of safely and not left unattended TECHNICAL SPECIFICATIONS 1 SAFETY Read and save this instruction manual (pay special attention to the safety instructions at the back) 3 Avoid damage that can be caused by screws, nails and other elements in your workpiece; remove them before you start working Check voltage indicated on nameplate of tool/charger/ battery In case of electrical or mechanical malfunction, immediately switch off the tool or unplug charger from power source SKIL can assure flawless functioning of the tool only when original accessories are used Before using accessories always compare the maximum allowed r. p. m. of the tool This tool should not be used by people under the age of 16 years Be careful not to drill or drive into areas where electrical wires may be contacted Do not activate switch when changing accessories or carrying the tool CHARGING/BATTERIES Charge battery only with the charger that is supplied with the tool Do not touch the contacts in the charger Do not expose tool/charger/battery to rain Never charge battery outdoors 4 Store tool/charger/battery in locations where temperature will not exceed 40° C or drop below 0° C Batteries will explode in fire, so do not burn battery for any reason When damaged, and under extreme usage and temperature conditions, batteries may start to leak - if liquid comes into contact with the skin, wash quickly with soap and water, then with lemon juice or vinegar - if liquid gets into the eyes, flush eyes with clean water for a minimum of 10 minutes and seek immediately medical attention When battery is not in tool or charger, it should be kept away from metal objects such as nails, screws, keys etc. [. . . ] CE DÉCLARATION DE CONFORMITÉ Nous déclarons sous notre propre responsabilité que ce produit est en conformité avec les normes ou documents normalisés suivants: EN 60 335, EN 55 014, EN 50 260, conforme aux réglementations 73/23/EEC, 89/336/EEC, 98/37/EEC. BRUIT/VIBRATION Mesuré selon EN 50 260 le niveau de la pression sonore de cet outil est < 70 dB(A) et la vibration < 2, 5 m/s2 (méthode main-bras). CE KONFORMITÄTSERKLÄRUNG Wir erklären in alleiniger Verantwortung, daß dieses Produkt mit den folgenden Normen oder normativen Dokumenten übereinstimmt: EN 60 335, EN 55 014, EN 50 260, gemäß den Bestimmungen der Richtlinien 73/23/EWG, 89/336/EWG, 98/37/EWG. GERÄUSCH/VIBRATION Gemessen gemäß EN 50 260 beträgt der Schalldruckpegel dieses Gerätes < 70 dB(A) und die Vibration < 2, 5 m/s2 (Hand-Arm Methode). CE CONFORMITEITSVERKLARING Wij verklaren, dat dit product voldoet aan de volgende normen of normatieve documenten: EN 60 335, EN 55 014, EN 50 260, overeenkomstig de bepalingen van de richtlijnen 73/23/EEG, 89/336/EEG, 98/37/EEG. GELUID/VIBRATIE Gemeten volgens EN 50 260 bedraagt het geluidsdrukniveau van deze machine < 70 dB(A) en de vibratie < 2, 5 m/s2 (hand-arm methode). CE KONFORMITETSFÖRKLARING Vi intygar och ansvarar för, att denna produkt överensstämmer med följande norm och dokument: EN 60 335, EN 55 014, EN 50 260, enl. LJUD/VIBRATION Ljudtrycksnivån som uppmätts enligt EN 50 260 är på denna maskin < 70 dB(A) och vibration < 2, 5 m/s2 (hand-arm metod). CE KONFORMITETSERKLÆRING Vi erklærer under almindeligt ansvar, at dette produkt er i overensstemmelse med følgende normer eller normative dokumenter: EN 60 335, EN 55 014, EN 50 260, i henhold til bestemmelserne i direktiverne 73/23/EØF, 89/336/EØF, 98/37/EØF. STØJ/VIBRATION Måles efter EN 50 260 er lydtrykniveau af dette værktøj < 70 dB(A) og vibrationsniveauet < 2, 5 m/s2 (hånd-arm metoden). CE MINÖSÉGI TANUSITVANY Teljes felelösségünk tudatában kijelentjük, hogy jelen termék a következö szabványoknak vagy kötelezö hatósági elöírásoknak megfelel: EN 60 335, EN 55 014, EN 50 260, a 73/23/EWG, 89/336/EWG, 98/37/EWG elöírásoknak megfelelöen. ZAJ/REZGÉS Az EN 50 260 alapján végzett mérések szerint ezen készülék hangnyomás szintje < 70 dB(A) a kézre ható rezgésszám < 2, 5 m/s2. CE STRVZUJÍCÍ PROHLÅENÍ Potvrzujeme na odpovdnost, e tento v¥robek odpovídå nåsledujícím normåm nebo normativním podkladüm: EN 60 335, EN 55 014, EN 50 260, podle ustanovení smrnic 73/23/EWG, 89/336/EWG, 98/37/EWG. HLUÇNOSTI/VIBRACÍ M®eno podle EN 50 260 çiní tlak hlukové vlny tohoto p®ístroje < 70 dB(A) a vibrací < 2, 5 m/s2 (metoda ruka-pae). [. . . ] DECLARAØIE DE CONFORMITATE CE Declaråm pe proprie råspundere cå acest product este conform cu urmåtoarele standarde sau documente standardizate: EN 60 335, EN 55 014, EN 50 260, în conformitate cu regulile 73/23/EEC, 89/336/EEC, 98/37/EEC. ZGOMOT/VIBRAØII Måsurat în conformitate cu EN 50 260 nivelul de presiune a sunetului generat de acest instrument este de < 70 dB(A) iar nivelul vibraøiilor < 2, 5 m/s2 (metoda mînå - braø). CE KPA A COTETCTBE , : EN 60 335, EN 55 014, EN 50 260, 73/23/EEC, 89/336/EEC, 98/37/EEC. [. . . ]