User manual SKIL 2875

[. . . ] Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Keep by-standers, children, and visitors away while operating a power tool. Key that is left attached to a rotating part of the tool may result in personal injury. [. . . ] If the liquid contacts your eyes, flush them with water for a minimum of 10 minutes and seek medical attention. Place charger on flat non-flammable surfaces and away from flammable materials when re-charging battery pack. Carpeting and other heat insulating surfaces block proper air circulation which may cause overheating of the charger and battery pack. If smoke or melting of the case are observed unplug the charger immediately and do not use the battery pack or charger. Use of an attachment not recommended or sold by Skil may result in a risk of fire, electric shock or injury to persons. This symbol designates that this tool is listed by Underwriters Laboratories, and listed to Canadian Standards by Underwriters Laboratories. This symbol designates that this tool is listed by Underwriters Laboratories. This symbol designates that this tool is listed by the Canadian Standards Association. This symbol designates that this tool complies to NOM Mexican Standards. WARNING off position before making any assembly, adjustments or changing Disconnect battery pack from tool or place the switch in the locked or accessories. Such preventive safety measures reduce the risk of starting the tool accidentally. Tool Model number Voltage rating No load speed Charge time Maximum Capacities Blade 5-3/8" Depth of cut at 90° 1-5/8" Depth of cut at 45° 1-1/4" 92994 or 144BAT 92995 or 180BAT Battery pack For replacement blades we recommend Skil Cordless Circular saw blades. Their thin kerf and tooth design deliver the best speed, quality of cut, and reduce battery drain. WARNING from tool or place the switch in the locked or off position before making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally. Turn BLADE STUD with wrench provided clockwise and remove BLADE STUD and OUTER WASHER (Fig. If the shaft moves while attempting to loosen the blade stud, strike the wrench counter-clockwise to jar BLADE STUD loose. While retracting the lower guard, check operation and condition of the LOWER GUARD SPRING. Make sure the saw teeth and arrow on the blade point in the same direction as the arrow on the lower guard. Slide blade through slot in the foot and mount it against the INNER WASHER on the shaft. Be sure the large diameter of the OUTER washer lays flush against the blade. The face of outer washer has marks around it that will help you properly adjust the blade stud. [. . . ] Of its maximum capacity with its first few Remember to unplug charger during storage charge cycles. Check to see if outlet is connected to a temperature is between 40°F (4°C) and light switch which turns power "off" when 105°F (41°C). Charge may mean that the battery pack is nearing the end of its life and should be Clean with cotton swab and alcohol if necessary. A month or more) of non-use of your tool, it is best to take or send tool, battery pack and charger run your tool down until it is fully discharged to your local Skil Service Center. [. . . ]