User manual SKIL 3375-01

[. . . ] All repairs, electrical or mechanical, should be attempted only by trained repairmen. Learn its application and limitations as well as the specific potential hazards peculiar to this tool. Do not operate while under medication or while using alcohol or other drugs. WEAR PROPER APPAREL Do not wear lose clothing, gloves, neckties, rings, bracelets, or other jewelry which may get caught in moving parts. [. . . ] Your unit is for use on 120 volts; it has a plug that looks like the one in Figure 1. In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This tool is equipped with an electric cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into a matching outlet that is properly installed and grounded in accordance with all local codes and ordinances. Before connecting the motor cord to power source, make certain the switch is in the "OFF" position and be sure the electric current is of the same characteristics as stamped on the sander nameplate. This power tool is equipped with a 3-conductor cord and grounding type plug, approved by Underwriters Laboratories and the Canadian Standards Association. The ground conductor has a green jacket and is attached to the tool housing at one end and to the ground prong in the attachment plug at the other end. If the outlet you are planning to use for this power tool is of the two-prong type, DO NOT REMOVE OR ALTER THE GROUNDING PRONG IN ANY MANNER. have a qualified electrician replace the TWO-prong outlet with a properly grounded THREE-prong outlet. Improper connection of the equipment-grounding conductor can result in a risk of electric shock. The conductor with insulation having an outer surface that is green with or without yellow stripes is the equipmentconductor. If repair or replacement of the electric cord or plug is necessary, do not connect the equipmentgrounding conductor to a live terminal. Check with a qualified electrician or service personnel if the grounding instructions are not completely understood, or if in doubt as to whether the tool is properly grounded. To keep this to a minimum and to prevent overheating and motor burn-out, use the table below to determine the minimum wire size (A. Use only 3-wire extension cords which have 3-prong grounding type plugs and 3-pole receptacles which accept the tool's plug. This machine must be grounded while in use to protect the operator from electric shock. Plug power cord into a 110-120V properly grounded type outlet protected by a 15-amp dual element time delay fuse or circuit breaker. If you are not sure that your outlet, as pictured in Figure 1, is properly grounded; have it checked by a qualified electrician. To avoid electric shock, do not touch the metal prongs on the plug when installing or removing the plug to or from the outlet. Failure to properly ground this power tool can cause electrocution or serious shock, particularly when used near metal plumbing or other metal objects. If power cord is worn, cut or damaged in any way, have it replaced immediately to avoid shock or fire hazard. To reduce the risk of injury, never connect plug to power source outlet until all assembly steps are complete and until you have read and understood the entire owner's manual. [. . . ] Turn switch "OFF" and always remove plug from the power source before trouble Extension cord too light or too long. Pour ne pas risquer de pincer l'ouvrage ou les doigts entre le support de l'ouvrage et la surface de ponçage, le bord du support doit être à un maximum de 1-2 mm de la surface de ponçage. Pour ne pas risquer de pincer l'ouvrage ou les doigts entre le support de l'ouvrage et la surface de ponçage, le bord du support doit être à un maximum de 1-2 mm de la surface de ponçage. Retirez le boulon et le verrou de support de l'ouvrage, et enlevez le support de l'ouvrage. [. . . ]